CA
B
Fig. 2
DESCRIPTION
Due to the popularity of CAT5 cable for use on video intercom sys-
tem Videx have developed the Art.316C, a 4 way distribution box
with RJ-45 connections for the VX2200 6 wire bus video system.
It distributes the power (+ & –), the bus (L & –) and the video
(V1 & V2) from the main bus to 4 apartment outputs with RJ-45
connector.
The distributor also include an in and an out connection to con-
nect multiple Art.316C devices on the same bus.
The main bus connections include both RJ-45 and terminal con-
nections should a larger cable be required for the main bus en-
abling distanced of up to 400m.
LEGEND
APower LED.
When o this indicates there is no voltage between the ter-
minals “+” (plus) and “–” (minus).
Check that the wires are not interrupted or that the +20Vdc
power supply unit is connected to mains.
BBUS LED.
When o this indicates there is no bus voltage which could
be he result of a short, a broken wire or if there is no master
door panel or concierge connected.
CVideo line termination switch.
End of line termination for the video. This should be set to“C”
(Closed) on the end of line device only.
KEY FEATURES
• Allows the installer to use standard CAT5 cable crimped to an RJ-45 plug
• 1 input / 1 output RJ-45 connection or standard 6 wire screw terminals
• 4 RJ-45 outputs to connect directly to 6000 Series monitors
• 1 switch to terminate the impedance of the video signal (End of Line)
• 2 fault diagnostic LED’s to indicate bus and power.
MATCHING SIGNALS OVER CAT5
EIA/TIA568B
1
2
3
4
5
6
7
8
o
O
g
B
b
O
br
BR
8
7
6
5
4
3
2
1
BR
br
G
b
B
g
O
oEIA/TIA-568B
RJ-45 pin VX2200 Signal
1and 2 (white-orange / orange) L
3and 4 (white-green / blue) –
5and 6 (white-blue / green) +
7 (white-brown) V1
8 (brown) V2
EIA/TIA568A
1
2
3
4
5
6
7
8
g
G
o
B
b
O
br
BR
8
7
6
5
4
3
2
1
BR
br
O
b
B
o
G
gEIA/TIA-568A
RJ-45 pin VX2200 Signal
1and 2 (white-green / green) L
3and 4 (white-orange / blue) –
5and 6 (white-blue / orange) +
7 (white-brown) V1
8 (brown) V2
NOTE: DO NOT USE CROSS OVER CABLES.
IMPORTANT NOTE: SOLID COPPER CABLES MUST BE USED. COPPER COATED STEEL CCS AND COPPER COATED
ALUMINIUM CCA CAN NOT BE USED ON THE SYSTEM.
TECHNICAL SPECIFICATION
Housing/Mounting: ABS plastic box / surface mount
Power Supply: 20V dc
Power consumption: Stand-by: 8mA Max: 40mA
Working Temperature: -10 +50 °C
ENG