Viking PA-15 User manual

Viking PA-15 Overhead Paging ystem Configuration
To configure a Viking PA-15 Overhead Paging ystem for 8x8 services, move the FX /FXO witch to FX and leave
DIP switches 1-10 in default settings. Learn more.
Objective
Configuring a Viking PA-15 overhead paging system for 8x8 services.
Applies To
Viking PA-15 overhead paging system
Procedure
1. Move the FXS/FXO Switch to FXS.
2. Leave DIP switches 1-10 in their default settings ( witch 4 and 8 are ON by default; all others are OFF by default).
Note: If you do not want to hear a beep sound when paging, turn DIP Switch 8 OFF.
3. Connect the phone line or RJ11 cable to your 8x8 adapter.
4. Use a wire cutter to strip the other end of the cable and attach the wires to the corresponding pins on the PA-15:
◦Red Wire (Ring): Pin 5
◦Green Wire (Tip): Pin 6
Note: The black and yellow wires of the cable are not used.
5. Connect the speakers to Pin 1 and Pin 2 on the PA-15.
https://support.8x8.com/equipment-devices/overhead-paging/viking-pa-15-overhead-paging-system-configuration-for-8x8-serv…
Updated: Thu, 30 Jul 2020 16:00:11 GMT
Powered by
1

Additional Information
The Viking PA-15 device:
• Has 15 watts of output power.
• Can support up to 15 8-ohm speakers.
If you are seeking a higher output, you may be interested in the Viking PA-30 instead (30W output; supports up to 30
8-ohm speakers).
https://support.8x8.com/equipment-devices/overhead-paging/viking-pa-15-overhead-paging-system-configuration-for-8x8-serv…
Updated: Thu, 30 Jul 2020 16:00:11 GMT
Powered by
2