Vingtor Stentofon VSP-211M-L User manual

USER GUIDE A100K10756
Amplified Batteryless Telephone System
VSP-M 20 WAY

About this document
This document is intended for users of all version 6.0 VSP-M
station models (VSP-211M-L, VSP-212M-L, VSP-213M-L,
and VSP-22M). The system can handle up to 20 stations.
Extension Number Conguration
Each VSP-M station must have its own unique extension
number, 00 to 19, set by DIP switches. The DIP switches are
activated by sliding them to the ON position.
To set the extension number:
1. Remove jumpers from pins J2 and J3.
2. Set the first digit (Group) in the extension number
according to: switch 11 = 0 or switch 12 = 1
3. Set the second digit in the extension number according
to: switch 1 to 10 where switch 1 = 0, switch 2 = 1 ....
switch 10 = 9
Example:
–For extension no. 03, set switch 11 and 4 to ON.
–For extension no. 11, set switch 12 and 2 to ON.
Figure 1: DIP switches for setting VSP-M extension number 11
For information on all extension number settings, see
section 7: DIP Switch Settings for Extension Numbers in
A100K10758 VSP-M Technical Manual .
Extension Number Label
A label strip with numbers 00 to 19 is shipped with each
station.
●Fix the label with the relevant extension number in the
frame next to the text Station no at the front of the
station.
Figure 2: Fix extension number label on the upper right corner

Station Operation
To make a call to another station:
1. Set the extension number (00 - 19) of the station you
wish to call:
–Select the first digit by setting the Group switch to
either 0 or 1.
–Select the second digit by setting the rotary switch (Line
Selector) to numbers from 0 to 9 (numbers 10 and 11
are blocked).
–Example: to make a call to extension number 15, set the
Group switch to 1 and the rotary switch to 5.
2. Turn the crank clockwise until a loud beeping tone is
heard from the station.
–About 5 to 6 turns will be required.
3. Lift the handset, press the button on the handset and
keep it pressed during the entire conversation.
You may now converse with full power and without distortion
for a guaranteed period of 20 minutes.
Troubleshooting
Problem 1
The VSP-M station does not receive calls. There is no signal tone.
The issue could be that no extension number is set.
Possible solution:
Verify that the station has the correct address for the extenstion
number set on the DIP switches (see Figure 1).
Problem 2
VSP station receives calls from both groups.
Possible solutions:
–Verify that only DIP switch 11 for GROUP 0 or only DIP
switch 12 for GROUP 1 are set to the ON position.
–Remove jumpers from pins J2 and J3.
Problem 3
When mounting sparepart board, no call tone is heard.
Possible solution:
When using boards with inductors, remove jumpers from pins J6
and J7/J8 and insert a jumper on pin J9 located to the left of the DIP
switches.
Figure 3: Group and Line Selector

www.vingtor.com
Zenitel Norway AS
VINGTOR products are developed and marketed by Zenitel Norway AS. The company’s Quality Assurance System is certified to meet the requirements in NS-EN ISO 9001:2008. Zenitel Norway AS
reserves the right to modify designs and alter specifications without prior notice, in pursuance of a policy of continuous improvement. © 2010 Zenitel Norway AS.
[e-mail]
DOC NO.
A100K10756 30.5.2012