Vinotemp IL Romanzo IL-OW006-2Z User manual

B y
Owner’s Manual
6 - BottleDual-ZoneWine
Cooler
IL-OW006-2Z(6 bottle)

2
TABLE OF CONTENTS
IMPORTANT SAFETY INSTRUCTIONS ...................................................... 3
ELECTRICAL CONNECTION...................................................................... 4
INSTALLATION INSTRUCTIONS................................................................ 4
OPERATING YOUR WINE COOLER........................................................... 5
WALL INSTALLATION GUIDELINES .......................................................... 7
CARE AND MAINTENANCE ..................................................................... 9
PROBLEMS WITH YOUR WINE COOLER................................................ 10
TROUBLESHOOTING GUIDE.................................................................. 10

3
Please read and follow all safety rules and operating instructions before using.
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock or injury when using your appliance, follow these basic
precautions:
•Ensure that the wine cooler stays in the upright position during transportation.
•Place the wine cooler on a strong, level surface.
•This wine cooler is designed for indoor, household use only. Any other use will void the
warranty.
•Avoid placing the wine cooler in moist areas, near any heat source including direct sunlight, or
near any hazardous or flammable material.
•This unit must be freestanding and cannot be used as a built-in cooler.
•This cooler is designed to store wine bottles and should not be used to store food or other
i t e m s .
•An empty cooler can be a dangerous attraction to children. If disposing of the cooler, remove
gaskets, latches, lids or the entire door from your unused appliance, or take other action to
ensure the cooler is harmless. Leave shelves in so that children may not easily climb inside.
•Do not place any other objects on top of the wine cooler.
•Never lift or carry the wine cooler by the cord.
•Use of an extension cord for the wine cooler is not recommended. Directly connect the wine
cooler to an electrical outlet.
•This wine cooler is an electrical appliance. To avoid injury or death from electrical shock, do not
operate the wine cooler with wet hands, while standing on a wet surface or while standing in
w a t e r .
•To avoid injury or death from electrical shock, do not operate the wine cooler with wet hands,
while standing on a wet surface or while standing in water.
•To ensure proper internal air circulation, do not overfill the wine cooler.
•Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or
explosion.
-Save these instructions-

4
ELECTRICAL CONNECTION
For your protection, this unit is equipped with a 3-conductor cord set that has a molded 3-prong
grounding-type plug, and should be used in combination with a properly connected grounding-type
outlet.
•Do not under any circumstances cut or remove the third ground prong from the power cord
supplied. For personal safety, this appliance must be properly grounded.
•The cord should be secured behind the unit and not left exposed or dangling to prevent
accidental injury.
•When a standard 2-pin wall outlet is encountered, it is your responsibility to have it replaced
with a properly grounded 3-pin wall outlet.
•Never unplug the unit by pulling the power cord. To disconnect the
appliance, always grip the plug firmly and pull straight out from the wall
outlet. When moving the unit, be careful not to damage the power cord.
•The unit should always be plugged into its own individual electrical
outlet with a voltage rating that matches the rating label on the unit.
•Do not pinch or kink the power supply cord.
•Repair or replace all power cords that have become frayed or damaged.
Do not use a cord that shows cracks or abrasion damage along its length
or at either end. When moving the appliance, be careful not to damage
the power cord.
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
•Removeallpackingmaterialbeforeusingyourcooler.Checktobesureallpartsareincludedand
that the cooler is in good condition.
•Clean the interior surface with lukewarm water using a soft cloth before first use.
Installation of Your Wine Cooler
•This appliance is designed for free standing use only.
•Position the cooler in a dry and airy place. The recommended ambient temperature should
be between 50° and 80°F.
•Locatethewinecoolerawayfromdirectsunlightandsourcesofheatsuchasastove,heater,
radiator,etc.Directsunlightmayaffecttheacryliccoating.Sourcesofheatmayincrease
electric consumption. Extreme ambient temperatures may cause the unit to malfunction.
•Avoid locating the unit in moist areas.
•Place your cooler on a solid, level surface (other than carpet). This will ensure vibration and
noise-freeoperation.Tolevelyourwinecooler,adjustthefrontlevelinglegsatthebaseof
the coole r .
Improper use of the grounded plug can result in the risk of electrical shock. If the
p o w e r cordisdamaged,frayedorshowscracksorabrasionsacrossitslength,haveit
replaced at an authorized service center.
Extension Cord
C A U T I O N : It is strongly recommended that you do not use an adapter or an extension cord with this unit.

5
D e f r o s t i n g :
1. Yourwinecoolerwilldefrostevery8hoursforaperiodofapproximately30minutes.
Condensation will accumulate in the evaporator drip tray and will eventually evaporate.
While your cooler is defrosting, the temperature displayed may be higher than the
temperature set.
2. You may notice condensation on the glass exterior of your unit. If you notice an excessive
amount of condensation on or around your unit, please relocate it to a less humid
location.
D r a i n :
1. Your wine cooler is equipped with a drain to release any excess liquid which may build up
inside the unit.
2. Werecommendroutingthedrainorwaterpipeintothedriptray.Pleaserefertothe
diagram shown on page 8 for instruction on drip tray installation.
OPERATING YOUR WINE COOLER
Recommended temperatures for wine storage:
Red Wines: 15-18
0
C (5 9-64
0
F)
Dry /White Wines 9-14
0
C (4 8-57
0
F)
Sparkling Wine 5-8
0
C (41-46
0
F)
The above temperatures may vary slightly depending on whether or not the interior bulb is ON or
OFF or whether the bottles are located in the upper/middle or lower section.
Operating your wine cooler as a two-zone wine cooler
Please place your wine cooler in a location where the ambient temperature is between 16-35℃/
60-95°F. If the ambient temperature is above or below this range, the performance of the unit
may be affected. For example, placing your unit in extreme cold or hot conditions may cause
interior temperatures to fluctuate.
ON/OFF Power
To turn the appliance on or off, press the ON/OFF button for 3 seconds.
Setting the temperature control
Each cooling compartment of the Wine Cooler (left and right) is independently controlled. To set
the temperature:
1. Connect the power cord to a properly grounded outlet. In the event of a power
interruption, all previous temperature settings are automatically erased and each
compartmentwilldefaulttoapresettemperaturesettingof5℃/ 41°F for left

6
compartment and 12℃/ 54°F for right compartment.
2. Set the desired cooling temperature by pressing the corresponding buttons for“set
lower” program. Pressing the button once will decrease the temperature by 1 degree.
The temperature selected will flash in the LED display for approximately 5 seconds and
thenrevertbacktodisplaythetemperatureoftheinternalcooler.Theleftz o n e can be
adjusted from 5℃/41°Fto10℃/ 50°F. The right zone’s temperature setting can be
adjusted from 10℃/ 50°F to 18℃/ 64°F. When using your cooler we recommend you
maintain 7 degrees difference between the left temperature zone and the right.
3. T o v i e w the “set” temperature, press once. The “set” temperature will temporarily
flash in the LED display for 5 seconds.
RUN
This indicator light will illuminate when the cooling mode is currently in operation.
Light
You can turn the interior light ON or OFF by pushing the button marked with the “bulb” symbol.
For best storage of wine, keep the light off except when viewing.
LOCK
Press the “LOCK” button for 3 seconds to lock the control panel. To unlock the control panel,
press the “LOCK” button again.
To switch between Celsius and Fahrenheit readings, press the “LOCK” and “LIGHT” buttons
simultaneously for 3 seconds.
NOTE:
-If the unit is unplugged, turned off or if there is a power failure, you must wait 3 to 5 minutes
beforerestartingtheunit.Ifyouattempttorestartbeforethistimedelay,thewinecoolerwill
not start working.
-Whenyouusethewinecoolerforthefirsttime,orrestartthewine cooler after having been
shutoffforalongtime,there could be a few degrees variance between the temperature you
select and the one indicated on the LED readout. This is normal and is due to the length of the
inactivation time. Once the wine cooler is running for a few hours everything will return to
normal.
-Thetopofthecoolerhas6bottleholes.Thetwoontheleftsidearethelowtemperaturezone.
The four on the right side are the high temperature zone. Temperature may fluctuate depending
on the ambient temperature and the seal of the wine cooler.

7
WALL INSTALLATION GUIDELINES
Add on the adjustable feet/bumpers to the back of each screw on the rear of the wine cooler.
This will ensure that your wine cooler has enough room between it and the wall to properly
exhaust.
Place the M8 boring crowns against the wall and use them as a guide for where to drill your
holes. The diagram above shows the required space between each hole. Use the screws (part B)
to affix the boring crowns to the wall.

8
Attach Part A to the back of the unit. Slide Part A into the boring crowns to affix your unit to the
wall.
Drip Tray Installation
1. Affix the mount for the drip tray to the bottom of the cooler as shown in the diagram above.
2. Route the water pipe into the drip tray.
3. Place the drip tray into the mount.

9
Note: Space for the drip tray is limited. For wall installation, we recommend that the water
pipe be routed to a separate container. Check your drip tray regularly for condensation and
empty as needed to avoid leakage.
CARE AND MAINTENANCE
Cleaning Your Wine Cooler
I M P O R T A N T : Always unplug the unit before cleaning or performing maintenance. Never use harsh
cleansers or scouring pads to clean any part of the unit.
•Before cleaning your wine cooler, turn the power off, unplug the appliance, and remove its
c o n t e n t s .
•Washtheinsideofthewinecoolerusingwarmwaterandabakingsodasolution(2
tablespoons of baking soda to 1 quart of water).
•Wring any excess water outofthespongeorclothwhencleaningthecontrolpanelorany
electrical parts.
•Wash the outside of the wine cooler using warm water and a mild liquid detergent. Rinse well
and wipe dry with a soft and clean cloth.
Power Failure
•The temperature of your appliance will remain steady for a few hours in the event of a
power failure. Minimize the number of times the door is opened.
•Ifyourpowerwillbeoffforalongerperiodoftime,youneedtotakeproperstepsto
protect the coolers contents.
Moving Your Wine Cooler
Before moving your wine cooler, first be sure to remove all items from the cooler.
•Securely tape down any loose items, such as shelves, inside the unit.
•Turn the adjustable leg up to the base to avoid damage.
•Tape the door shut.

10
•Ensure that the unit stays securely in the upright position during transportation. Protect the
outside of the appliance with a blanket.
Energy Saving Tips
Locate your wine cooler in the coolest area of your room, away from heat producing appliances
and out of direct sunlight.
PROBLEMS WITH YOUR WINE COOLER
YoucansolvemanycommonWineCoolerproblemseasily,savingyouthecostofapossible
servicecall.Trythesuggestionsbelowtoseeifyoucansolvetheproblembeforecallingthe
servicer.
Contact our Customer Service at 1-800-777-8466 or [e-mail].
TROUBLESHOOTING GUIDE
P R O B L E M
POSSIBLE CAUSE
Wine cooler does not operate.
Not plugged in.
The appliance is turned off.
The circuit breaker has tripped or a fuse
has blown.
Wine cooler is not cold enough.
Check the temperature control setting.
External environment may require a higher
s e t t i n g .
Turns on and off frequently.
The room temperature is hotter than
normal.
Alargeamountofcontentshasbeen
added to the wine cooler.
Thetemperaturecontrolisnotset
c o r r e c t l y .
The light does not work.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The bulb has burned out.
The light button is “OFF”.
Vibrations.
Make sure your wine cooler is level.
The wine cooler is making too much noise.
Somenoisemaycomefromtheflowofthe
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
soundscausedbytheflowofrefrigerantin
your Wine cooler.
Contraction and expansion of the inside
walls may cause popping and crackling
noises.
The wine cooler is not level.