Vinyl Works CNKDK User manual

MODEL CNKDK ~ CONNECTOR KIT
USED TO JOIN VWC RESIN POOL FENCING TO
• MODEL SLA A-FRAME POOL LADDER
• MODEL CS STEP ENTRY SYSTEM
• or DECKS
877-VINYL WK www.vinylworkscanada.com

The connector kit can be used to join the pool fencing directly to a pool deck. Install the fence as per the instructions packaged
within leaving the section on either side of the deck open. Decide whether the fence is to mount flush to the face of the deck post
or mount on the side of the post (see diagram below). Using a spare fence rail mark the required location of the connector
brackets on each side of the deck. Make certain the rail remains level. Using a connector bracket mark the required screws
locations for each bracket. If the deck post is not made of wood you may want to pre-drill a 1/8” pilot hole for the screw. Secure
each connector bracket in place appropriately. Make certain not to over-tighten the screws as you may strip the holes. Measure
and cut the remaining fence rails / sections for both sides of the deck. Refer to your fence installation instruction to complete
these two remaining sections. Remember to balance the sections and pickets within on both sides for a “neat” appearance. Make
certain to measure the fence rails to include the length / amount required to fit within the connector brackets and fence posts on
both ends. Assemble & install the remaining sections and secure rail ends using the screws washers and caps provided.
Side
Moun