SMD-426 PG2 is a fully supervised wire-
less photoelectric smoke detector that
is compatible with PowerMaster®wire-
less burglar alarm systems. Designed
for a wide range of residential and
commercial applications, this easily in-
stalled smoke detector has a stream-
lined design and an extended battery
life for easy and low-cost maintenance.
SMD-426 PG2
Two-way Wireless Smoke
Detector
Features & Benets:
•PowerG®two-way Frequency Hopping
Spread Spectrum FHSS-TDMA technology -
provides robustness and reliability closer
than ever to wired
•Longer battery life for 5-8 years (with
typical use, according to battery type)
•Provides sound and transmitted alerts
(for smoke, tamper, low battery)
•Loud (85db) alarm sound at 3m (10ft)
•Large transmission range enabling
repeater-free installations
•Visible signal quality indication shown
on the device
•Simple wall or ceiling installation, with
bracket
•Back tamper
•Fullycertiedbythemoststrictand
demanding international standards such as
EN 14604 for safety products in Europe, and
designed to comply with UL 268 in the USA.
Specications:
Battery type: 3V, CR123A / CR17450
Lithium battery
Weight
(including battery):
165g (5.8oz)
Operating
temperature:
-10°C to 50°C
(14°F to 122°F)
Operating
environment:
Indoor
Dimensions: 120 X 58mm
(4.7 X 2.3in)
Certications:
, PowerG and PowerMaster are registered trademarks of Visonic Ltd. Other names are the property
of their owners. Visonic reserves the right to change information or specications without notice.
