Vista Simplicity Rechargeable Motorization User manual

WOOD & FAUXWOOD BLINDS |
Simplicity Rechargeable Motorization
Quick Start Guide
Your blind has come pre-programmed from the factory. Follow these easy steps to get started.
1. Mount the blind. 2. Your blind is now ready!
Select the programmed channel and use the
UP and DOWN arrows to operate the blind.
For more in depth motorization programming instructions, please visit vistaproducts.com/guides
Setting/Using a Favorite Position
Make sure there is only one blind programmed to the channel when setting a Favorite position.
If more than one blind is set, please see UNLINK A BLIND in the Simplicity guide at vistaproducts.com/guides.
1. Using the UP and DOWN arrows,
move the blind to the desired
Favorite position.
2. To save the Favorite position, hold the
LIMIT button and hold the UP button at the
same time. Release after a series of short beeps.
3. Press the STOP/FAVORITE button to
move the blind to the set Favorite position.
NOTE: Make sure blind is fully stopped
before using the Favorite position.

For more in depth motorization programming instructions, please visit vistaproducts.com/guides 7/19K2190
6 CHANNEL TIMER REMOTE |
Simplicity Rechargeable Motorization
Quick Start Guide
Your shade has come pre-programmed from the factory. Follow these easy steps to get started.
2. Mount the shade. 3. Your shade is now ready!
Press the AUTO/MANUAL button until the display
shows ‘Manual’. Select the programmed channel and
use the UP and DOWN arrows to operate the shade.
Setting Time and Day
Make sure the remote is in ‘Manual’ mode. Press the AUTO/MANUAL button until ‘Manual’ appears on the screen.
1. Push and hold the LIMIT button.
While holding the limit button, push the
AUTO/MANUAL button for 3 seconds
and release. e hour digits will ash.
2. Use the UP and DOWN buttons to set the
current hour. Press the CHANNEL button to
conrm hour and advance to minutes.
NOTE: Time is in 24 hour format.
3. Repeat step 2 for minutes and day.
Once time and day are set, hold the AUTO/
MANUAL button for 3 seconds. Display will
ash and then display current time and day.
1. Connect the motor and battery
in the headrail (as shown).
Connect