Vista Simplicity Cellular Shades User manual

CELLULAR SHADES |
Simplicity Rechargeable Motorization
Quick Start Guide
Your shade has come pre-programmed from the factory. Follow these easy steps to get started.
2. Mount the shade. 3. Your shade is now ready!
Select the programmed channel and use the
UP and DOWN arrows to operate the shade.
1. Connect the motor and battery
in the headrail (as shown).
Connect
For more in depth motorization programming instructions, please visit vistaproducts.com/guides
V
ista
Setting/Using a Favorite Position
Make sure there is only one shade programmed to the channel when setting a Favorite position.
If more than one shade is set, please see UNLINK A SHADE in the Simplicity guide at vistaproducts.com/guides.
1. Using the UP and DOWN arrows,
move the shade to the desired
Favorite position.
2. To save the Favorite position, hold the
LIMIT button and hold the UP button at the
same time. Release after a series of short beeps.
3. Press the STOP/FAVORITE button to
move the shade to the set Favorite position.
NOTE: Make sure shade is fully stopped
before using the Favorite position.

6 CHANNEL TIMER REMOTE |
Simplicity Rechargeable Motorization
Quick Start Guide
Your shade has come pre-programmed from the factory. Follow these easy steps to get started.
2. Mount the shade. 3. Your shade is now ready! Press the CLOCK
button until the display shows ‘Manual’. Select the
programmed channel and use the UP and DOWN
arrows to operate the shade.
For more in depth motorization programming instructions, please visit vistaproducts.com/guides
V
ista
Setting Time and Day
NOTE: To turn the remote on, press the POWER button on the right side of the remote.
Make sure the remote is in ‘Manual’ mode. Press the CLOCK button until ‘Manual’ appears on the screen.
1. Push and hold the LIMIT button.
While holding the limit button, push the
CLOCK button for 3 seconds and release.
e hour digits will ash.
2. Use the UP and DOWN buttons to set the
current hour. Press the CHANNEL button to
conrm hour and advance to minutes.
NOTE: Time is in 24 hour format.
3. Repeat step 2 for minutes and day.
Once time and day are set, hold the CLOCK
button for 3 seconds. Display will ash and
then display current time and day.
11/18K2187
1. Connect the motor and battery
in the headrail (as shown).
Connect