Gimenez Ganga Saxun Stor Glass Avant Setup guide

Assembly and installation manual
Stor Glass Avant
MK1145 · EN · 02 · 0522
Giménez Ganga, S.L.U.
Polígono Industrial El Castillo
C/ Roma, 4
03630 • Sax (Alicante) • España
saxun.com EN
Place the frame in the window opening, without removing
the protective adhesive tape.
Warnings
Product Installation
Clean the marked areas of the window with alcohol.
Then, adjust the clips to be as close as possible to the corners.
General recommendations regarding safety, use
and restrictions
In order to ensure the safe assembly, use and maintenance of this product, a
number of precautionary measures must be taken. Please observe the following
warnings and instructions, for the safety of all concerned. If in doubt, contact
your dealer.
Please read this manual carefully
before starting work.
Some components may be sharp or
have jagged edges. It is therefore
advisable to wear safety gloves.
All parts supplied have been designed
specically for this product. The re-
placement or addition of other parts
may have a negative eect on the
safety of the product and its warranty.
Under no circumstances should a
damaged product be installed, as
it may damage the equipment and
create situations that are dangerous
for people.
These systems are exclusively inten-
ded for the use for which they were
designed. Any other use is inappro-
priate, and therefore dangerous.
The manufacturer will not be liable for
damage caused during the
installation due to non-compliance
with these recommendations.
1
2
1
2
3
1
1
1
1. Clean the window
2. Adjust the supports
Remove the protective adhesive tape.
Press each corner rmly against the
window for 5 seconds, starting with
the lower corners of the Stor
3. Install the product
Spring
system
Chain
system

Insert the piece with adhesive into the piece shown, applying pressure.
2.1 Attach the interior angle to the angle.
2.2 Place the shown half of the thread clip in position.
2.3 Insert two clips into the prole groove as shown, with the same dimensions
in the two proles, equivalent to the height of the window. And one in the
remaining prole.
2.4 Place the angles at both ends and attach them to the uneven prole, using 4
normal screws and 2 left-hand screws.
3.1 Position the lateral proles, joining the previously assembled bottom prole
to the Stor box.
3.2 Attach the assembly using the left-hand screws. Screw them diagonally into
the angles.
3.3 Repeat the operation with the remaining screws.
Starting with side A
4.1 With the other half of the clip, clamp the thread
4.2 Place the clip perpendicular to the plane of the Stor. Rotate
and hold the clip as shown.
4.3 Repeat the same process on side B, tightening the thread.
1. Clip proles
2. Bottom prole 3. Product assembly 4. Thread tension Spring system
Componentes
Spring system
Spring system
Chain system
2x Clip thread 2x Interior
antgle
Screws
6x 8x
5x Clip frame 3xProle frame
2x Angle
Product assembly
x2 x4 Phillips screwdriver
Gira a izquierda
1
2
5x
2x
3
4
x4 x4 Phillips screwdriver
2
1
4
3
A
A
1
1
3
3
2
2
4
4
B
B
Turn left