3
STEP 4
OPTION A: 3/4” - 1” (18mm - 25mm)
Desktop
Attach the lower clamp components to the
underside of the desk edge using ST3.9x25
self-tapping screws (C) (NOTE: For correct
fit, the space between the clamps must
be no more than 18” [455mm]). Slide the
upper clamp components onto the lower
clamps, and secure using the M6x25mm
bolts (E) and Allen wrench (H).
STEP 5
Slide the front clamp components
onto the upper clamps.
STEP 7
Insert the M6x12mm bolts (D) into the front clamps, and tighten with the Allen wrench (H).
OPTION B: 1” - 2” (25mm - 50mm)
Desktop
Slide the upper clamp components onto
the lower clamps, and partially insert
M6x25mm bolts (E) or M6x40mm bolts
(F) depending on the desktop thickness.
Place the clamps on the edge of the desk,
and tighten using the Allen wrench (H).
(NOTE: For correct fit, the space between
the clamps must be no more than 18”
[455mm]).
STEP 6
Place the panel into the
clamps, making sure the
panel is fit between the
plastic pads.
