Vivotek Fixed Dome Series User manual

User’s Manual
VIVOTEK Fixed Dome Series
AM-10H Recessed-mount Bracket
Rev. 1.0
Corresponding part number: VIO900073500

2
AM-10H Recessed-mount Bracket Mechanical Drawing
Compatible VIVOTEK Cameras
I
Fixed Dome series FD9167-HT-v2, FD9367-EHTV-v2, FD9365-EHTV-v2,
FD9391-EHTV-v2
You may also refer to VIVOTEK's website for the list of supported models. Support for other models can
be available through time.
Package Contents
• Recessed-mount bracket
• Screws: M6x12 SEMS x4
• Alignment sticker
• Installation Guide
Revision History
• Rev. 1.0: Initial release.

3
English
Installation
II
228mm
24mm
Up to
Ceiling Hole Template Sticker
186mm
Mounting Hole Denitions
1. Determine a secure location for the recessed-mount bracket.
2. Drill or cut a 228mm hole (in diameter). The maximum thickness of the ceiling/board is
24mm. The ceiling should be able sustain at least a weight of 3.3kg.
3. Remove dome cover from the
camera using the stardriver
included in kit.

4
5. Install camera to the recessed-mount bracket by driving screws.
4. Detach the dome cover from the recessed mount.

5
English
NOTE:
1. Connect and route cables before you secure the recessed-mount bracket to a ceiling.
2. For details on the cable connections with each camera, please refer to their Quick
Installation Guide.
Optional: You can tie up a tether line to the top of the bracket in case the bracket may fall
during the installatioin.

6
6. Connect cables to the camera.
6-1. Re-install the top cover of the camera.
7. Use a #2 Phillips screwdriver to loosen the clamping plates (see drawing below) and
insert the recessed-mount bracket through the hole in the ceiling.

7
English
8. Use a #2 Phillips screwdriver to move the clamping plates down so that the ceiling/
board is caught between the clamps and the ange on the other side of the ceiling.
Clockwise Counter-
clockwise
9. Adjust shooting angle and check for a satistory image over a web session. When you
have a satisifactory live view, secure the dome cover from below by turning it counter-
clockwise.
Microphone

8
10. You are done with the installation.