Vivotek Speed Dome Series User manual

IP Surveillance
Installation Guide
VIVOTEK Speed Dome Series
AM-103 Recessed-mount Bracket
Rev. 1.1
Corresponding part number: 900014000G

2
AM-103 Recessed-mount Bracket Mechanical Drawing
138.3
18.2
297
245.5
Compatible VIVOTEK Cameras
I
Speed Dome series SD8332E, SD8363E, SD8364E, SD83x4E, SD83x6E,
SD8333E
You may also refer to VIVOTEK's website for the list of supported models. Support for other models can
be available through time.
Package Contents
• Recessed-mount bracket
• Screws: 3x Roundhead M4x8
• Alignment sticker
IMPORTANT:
This recessed mount bracket is for indoor use only.
Revision History
• Rev. 1.0: Initial release.
• Rev. 1.1: Adeed SD8364E, SD83x4E, SD83x6E, SD8333E as the supported models.

3
English
Installation
II
260mm
48mm
Up to
Ceiling Hole Template Sticker
260mm
Mounting Hole Denitions
1. Determine a secure location for the recessed-mount bracket.
2. Drill or cut a 260mm hole (in diameter). The maximum thickness of the ceiling/board is
48mm. The ceiling should be able to sustain at least a weight of 6kgs.
3. Remove cover ring from the
mount bracket by turning it
clockwise.

4
M4X8
5. Fasten the black M4 machine screws to secure the interface section of the camera to
the recessed-mount bracket.
Ethernet
DI GND
DI4
DI3
DI2
DI1
DO2
DO1
DO+(12V)
AC24V
AC24V
Reserved
MIC IN
Line OUT
Audio GND
RS485-
RS485+
4. Remove the interface circuit board
from the interface section. Loosen
the two crosshead screws.

5
English
6. Attach the camera body to the interface section by aligning the indicator mark on the
camera with that on the interface section. Turn the camera counter-clockwise until the
indicator mark is aligned with the "C" mark.
Note that the dome cap section of the camera is not
used in this installation.

6
NOTE:
1. Connect and route cables before you secure the recessed-mount bracket to a ceiling.
2. For details on the cable connections with the camera, please refer to their Quick
Installation Guide.
Optional: You can tie up one or more tether lines
to the top or the sides of the bracket in case
the bracket should fall during the installation
process.
7. Turn the assembly over and place it carefully on the foam blocks that came with the
shipping package to prevent damage to the dome cover. Secure the anti-tamper screws
from the openings on the bracket using the included T25 stardriver.

7
English
9. Use a #2 Phillips screwdriver to loosen (turning clockwise) the clamping plates, and
then insert the recessed-mount bracket through the pre-drilled hole in the ceiling.
8. Connect cables to the camera. Please refer to the Quick Installation Guide for
connection pinouts.

8
10. Use a #2 Phillips screwdriver to move the clamping plates down so that the ceiling/
boardiscaughtbetweentheclampsandtheangeontheothersideoftheceiling.
Clockwise Counter-
clockwise
11. Align and attach cover ring to the bracket by turning it counter-clockwise.