Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Note: For these instructions PDS-LCB part numbers have hexagons
around their numbers and PDS-LCM2B part numbers have circles
around their part numbers.
Step 2
Attach the adjusting brackets PDS-LCM2B / PDS-LCB to the
mounting adaptor PDS-LCM2B using the M10 screws PDS-
LCM2B / PDS-LCB, washers PDS-LCM2B / PDS-LCB and
nylon nuts PDS-LCM2B / PDS-LCB. Insert the adjusting screw
PDS-LCM2B / PDS-LCB into the welded nuts located in
the mounting adaptor PDS-LCM2B Note: You will have to
thread the rst adjusting screw all the way down to provide space
to thread in the second screw. Once the second screw is started
you can back off the rst to the desired tilt angle.
Step 3
Mark the ceiling or desired mounting surface in preparation of
installation of ceiling plate PDS-LCB. If mounting to wooden
ceiling joists, pre drill pilot holes using a 7/32” drill bit. Attach the
ceiling plate PDS-LCB to the wooden ceiling joist using the
5/16” by 2.5” long lag screw PDS-LCB and washer PDS-LCB.
WARNING: Please verify that your mounting surface will support
the combined weight of your mount, mounting hardware, and at
panel. Also verify that the mounting surface is safe to drill through.
Please note only mounting hardware for mounting to wooden ceil-
ing joists will be provided with the unit. If mounting to a surface
other than wooden ceiling joists then other hardware will be re-
quired. If in doubt or uncertain about any of the above, please
contact a professional installer.
Step 4
Screw the outer mast PDS-LCB into the ceiling plate PDS-
LCB. Secure the outer mast by tightening the brake screw PDS-
LCB into the thread hole in the side of the ceiling plate. Attach
the inner mast PDS-LCB to the outer mast using the M8 screw
2PDS-LCB and nylon nut PDS-LCB. Attach the pipe couple
PDS-LCB to the bottom of the inner mast and secure the pipe
couple with a brake screw PDS-LCB.
Step 2 : Attaching the adjusting
brackets
Step 3: Attaching the ceiling
plate to the ceiling
Step 4 : Attaching the ceiling
mast to the ceiling plate
8
1
11
WARNING: The installer of these products must verify that the mounting surface, ceiling or
wall, will safely support the combined weight of all attached equipment and hardware.
Video Mount Products will not be held liable for the improper use or installation of its products.
10
7
12
1
25
10 22
21
26
1
1
19
46
21
11
3
1312
4
11
