Step 1
Before starting lay out all parts to your mount and match them to the
parts list provided. Verify that you have all your parts before attempt-
ing to assemble the mount.
Attaching the VMP046/048 to the ceiling
Step 2
Mark the ceiling or desired mounting surface in preparation of instal-
lation of ceiling plate . Pre-drill if necessary and mount the ceiling
plate to desired surface. Warning: Please verify that your mount-
ing surface will support the combined weight of your mount, mounting
hardware, and monitor. Also verify that the mounting surface is safe to
drill through. If in doubt, please contact a professional installer.
Step 3
Attach the top force arm to the extension tube using the M12
screw and washers . Thread the ¼” brake screw into the
extension tube and tighten the brake screw down to hold the
M12 screw in place.
Step 4
Connect the extension tube and the ceiling plate using the
5/16” screw and nylon nut . Proceed to step 7.
Attaching the VMP046/048 to the wall
Step 5
Mark the wall or desired mounting surface in preparation of instal-
lation of wall bracket . Pre-drill if necessary and mount the wall
bracket to desired surface. Warning: Please verify that your
mounting surface will support the combined weight of your mount,
mounting hardware, and monitor. Also verify that the mounting sur-
face is safe to drill through. If in doubt, please contact a profes-
sional installer.
Step 2: Attaching the ceiling
plate to the ceiling
(Lag screws are not included)
Step 3: Attaching the extension
tube to the top force arm
Step 4: Attaching the extension
tube to the ceiling plate
VIDEO MOUNT PRODUCTS
Step 5: Attaching the wall plate
1
2
1
8
10 2
18
11
10
1
14 2
12
3
18
