VMP LCD-1C User manual

325 Log Canoe Circle • Stevensville MD 21666 • www.videomount.com
Phone: [phone] • Fax: [phone]
LCD-1C

1. Before starting lay out all parts to
your mount and match them to the parts
list provided. Verify that you have all
your parts before attempting to assemble
the mount.
2. Next determine which VESA
standard plate you will be using (#5 or
#6) (75mm or 100mm respectively) and
attach the selected mounting plate (#5 or
#6) to the monitor to the swivel bracket
(#4) using the M6 screw that’s about 1.4
inches long (#9) and the nylon nut (#7).
Insert adjustable screw (#12) for use
when tilting the monitor. (Set this
assembly safely to the side for now.)
3. Mark the ceiling or desired mounting
surface in preparation of installation of
ceiling plate (#1). Pre-drill if necessary and
mount the ceiling plate (#1) to desired
surface. Warning: Please verify that your
mounting surface will support the combined
weight of your mount, mounting hardware,
and monitor. Also verify that the mounting
surface is safe to drill through. If in doubt
about either please contact a professional
installer.
4. Next attach the swivel bracket (#4) to the
support tube (#3) using the 3/8” screw that is 2”
long (#16), washers (#15) and nylon nut (#8).
Step 2 : Attaching the mounting
plate to the swivel bracket
Step 3 : Attaching
the ceiling plate to
the ceiling.
Step 4 : Attaching the swivel
bracket to the support tube.

5. Now attach the support tube (#3) to the extension
tube (#2) using the M12 screw that’s about 2.6” long (#10)
and washers (#11).
6. Attach the mounting plate (#5 or #6) to your LCD monitor using the M4 or M5
screws (#21 or #22) as appropriate.
7. Attach the extension tube (#2) to the ceiling plate (#1) using
the 5/16” screw 1.5” in length (#18) and nylon nut (#19). Secure
the M12 screw (#10) from slipping in the extension tube (#2) by
tightening the ¼” brake screw (#17) into the threaded hole in the
side of the extension tube (#2) using the Allen key (#20).
8. Insert end plugs (#14) into the support
tube (#3). Insert the cable clips (#13) by
pushing the arrow ends into the square holes in
the force arms. Please verify that all nuts and
screws are securely fastened.
Enjoy your mount!
WARNING: The installer of these products must verify that the mounting surface,
ceiling or wall, will safely support the combined weight of all attached equipment and
hardware. Video Mount Products will not be held liable for the improper use or
installation of its products.
Step 5 : Attaching
the support tube to
the extension tube
Ste
p
6 : Attachin
g
the monitor to the mountin
g
p
late
Step 7 : Connecting
the extension tube to
the ceiling plate