Vogue 330267 Wiring diagram

/
VOGUE Rangehood Integrated 520mm & 850mm

Dear Customer,
By following the recommendations contained in this Instruction Manual, our
appliance will give you constant high performance and will remain efficient for
many years to come.
Product Specification & Technical Parameters
Model 330276/330277
Rated Voltage 220~240V
Rated Power Frequency 50Hz
Light Power LED 4W x 1 / LED 10W x 1
Motor Power 140W/230W
Total Power 144W/240W
Motor 1
Diameter of Outlet Adapter 150mm
Dimension (mm) W516/846 X D281 X H300
RECOMMENDATIONS AND SUGGESTIONS
• The manufacturer will not be held liable for any damages resulting from
incorrect or improper installation.
• Please read this instruction manual before using this range hood.
• Please keep this instruction manual in a safe place for future reference.
• Only a qualified and trained service technician is to do the work of
installation and servicing.
• Check that the main voltage corresponds to the one indicated on the
rating plate fixed inside the hood.
• If the hood is used in conjunction with non-electrical appliances (e. g. gas
burning appliances), a sufficient degree of ventilation must be
guaranteed in the room to prevent the backflow of exhaust gas. The
kitchen must have an opening directly with the open air to guarantee the
entry of clean air.
• The minimum distance is 750mm from the range hood to a gas hob, and
650mm to an electric hob. If the installation instructions for gas hobs
specify a greater distance, this must be considered.

NOTE:Two or more people are required to install or move this appliance.
Failure to do so can cause physical injuries.
USING THE RANGEHOOD
• The rangehood has been designed only for internal domestic use.
• Never use it for purposes other than what it has been designed for.
• Never leave high naked flames under the hood when it is in operation.
• Adjust the flame intensity to direct it onto the bottom of the pan only;
making sure that it does not engulf the side of the pan.
• Deep fryer fat must be continuously monitored during use: overheated oil
can burst into flame.
• The hood shouldn’t be used by children or persons not skilled in its use.
MAINTENANCE
• Proper ongoing cleaning and maintenance of the range hood will assure
proper performance of the unit.
• Disconnect the rangehood from the main electrical supply before carrying
out any maintenance work.
• Clean the stainless steel baffle filters regularly and drain the oil collector.
• Clean the hood using a damp cloth and a neutral liquid detergent or warm
water.
WARNING!!
• In certain circumstances electrical appliances may be a danger hazard.
• Do not check the status of the filters while the cooker hood is operating
• Do not touch the light bulbs after appliance use
• Do not disconnect the appliance with wet hands.
• Avoid free flame, as it could damage the filters and create a fire hazard
• Constantly monitor any food being deep fried to avoid overheated oil
becoming a fire hazard
• Disconnect the electrical plug prior to any maintenance or servicing.
• Children using the rangehood must be under the supervision of adults.

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
b) Sufficient air is needed for proper combustion and exhausting of gases
through the flue (chimney) to prevent back drafting.
c) When cutting or drilling into a wall or ceiling, do not damage electrical
wiring and other hidden utilities.
d) The rangehoods must always be vented to the outdoors.
• Do not use this product outdoors.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction,
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
• There shall be adequate ventilation of the room when the range hood is
used at the same time as appliances burning gas or other fuels.
• There is a fire risk if cleaning is not carried out in accordance with
instructions.
• The exhaust air must not be discharged into a flue which is used for
exhausting fumes from appliances burning gas or other fuels.
STAINLESS STEEL BAFFLE FILTERS
The filters should be cleaned frequently. Use a warm detergent solution.
Grease filters are washable.
See “INSTALL FILTERS” section for removal and installation instructions.

DIMENSIONS
OPERATION OF CONTROLS
The hood is operated using the electronic switch on
the front panel.
The light switch turns the lamps on and off.
The blower switch turns the blower on to three speed
settings:
1 - LOW SPEED
2 - MEDIUM SPEED
3 - HIGH SPEED
LOCATION ABOVE COOKTOP
The minimum hood distance above the
cooktop must not be less than 650mm. A
maximum height of 750mm above the
cooktop is recommended for the most
efficient extraction of cooking odors.
Installations greater than 750mm above
the cooktop are at the installer’s and user’s
discretion.

INSTALLING THE DUCT WORK
(DUCTED HOODS ONLY)
Caution: To reduce the risk of fire, metal ductwork is preferred.
1. Decide where the ductwork
will run between the hood
and the outside.
2. A straight, short duct run will
allow the hood to perform
most efficiently.
3. Long duct runs, elbows, and
transitions will reduce the
performance of the hood.
Use as few of them as
possible. Larger ducting may
be required for best performance with longer duct runs.
4. The air must not be discharge into a flue that is used for exhausting
fumes from appliances burning gas or other fuels" "Regulations
concerning the discharge of air must be fulfilled.
5. Install a wall or roof cap. Connect round metal ductwork to cap and work
back towards hood location. Use duct tape to seal the joints between
ductwork sections.
ELECTRICAL INSTALLATION
Electrical wiring must be done by a qualified person(s) in accordance with all
applicable codes and standards. This range hood must be properly grounded.
Turn off electrical power at the switchboard before wiring.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons to avoid a hazard.

INSTALLING THE RANGEHOOD
NOTE: At least two people will be required to mount the hood.
1. Before beginning the installation remove all plastic film, the filters & the
oil catcher which is held in with 2 thumb screws. When it is removed
there are 3 cut outs to provide access to the screw mounting holes.
2. Before installing the hood to the cupboard unit drill a 165mm diameter
hole for the 150mm ducting in the top of the cupboard and ceiling.
3. Check the location of the power outlet and consider the location of the
power cord.
4. On the side of the hood are 2 spring clips to assist installation. Adjust the
height of the clip to match the thickness of the mounting panel. The hood
can then be slid into the opening and these springs will take some of the
weight while the screws are fitted.
5. Lift the rangehood and fit through the opening of the cabinet feeding the
ducting up through the pre-drilled holes.
6. Secure the unit using 6 long mounting screws, 3 on each side.
7. Refit the oil catcher being careful not to scratch the hood and then fit the
filters.
INSTALLING THE FILTERS
1. To remove the baffle filter, push on the metal latch tab. This will
disengage the filter from the hood. Tilt the filter downward and remove.
Be careful not to drop the filter.
2. To install the baffle filter slot the back edge into the channel and push
against the spring clips. The filter will swing up and lock into position.