Vogue RH.600.WH User manual

Thanks very much for choosing our product, please carefully read
the following important information regarding installation safety
and maintenance. And Keep this information booklet accessible
for further consultations.
RANGE HOOD INSTRUCTION MANUAL
MODEL: RH.600.WH

1
Dear Customer,
If you follow the recommendations contained in this Instruction Manual, our
appliance will give you constant high performance and will remain efficient
for many years to come.
Product Specification & Technical Parameters
Model
RH.600.WH
Rated Voltage
230V
Rated Power Frequency
50Hz
Light Power
1x25W
Motor Power
1x120W
Total Power
145W
Diameter of Outlet Adapter
120mm
Dimension(mm) W600 X D480 XH147
RECOMMENDATIONS AND SUGGESTIONS
INSTALLATION
* The manufacturer will not be held liable for any damages resulting from
incorrect or improper installation.
* Please read this instruction manual before installing and using this range
hood. Please keep this instruction manual in a safe place for future
reference.
* This range hood can be used either in the Ducted Mode (ducting fumes to
the outside) or in the Recirculation Mode (internal recycling). The choice of
modes can be left to the customers.
* Only a qualified and trained service technician can undertake the work of
installation and servicing.
* Check that the main voltage corresponds to the one indicated on the rating
plate fixed inside the hood.
* Do not connect the hood to exhaust ducts carrying combustion fumes
(boilers, fireplaces, etc.)
* If the hood is used in conjunction with non-electrical appliances (e. g. gas

2
burning appliances), a sufficient degree of ventilation must be guaranteed in
the room in order to prevent the backflow of exhaust gas. The kitchen must
have an opening directly with the open air in order to guarantee the entry of
clean air.
* The minimum distance is 750mm from the range hood to a gas hob, and is
650mm to an electric hob. If the installation instructions for gas hobs specify
a greater distance, this must be taken into account.
NOTICE: Two or more people are required to install or move this appliance.
Failure to do so can cause physical injuries.
USE
* The range hood has been designed only for domestic use to eliminate
kitchen fumes.
* Never use the hood for purposes other than what it has been designed for.
* Never leave high naked flames under the hood when it is in operation.
* Adjust the flame intensity to direct it onto the bottom of the pan only;
making sure that it does not engulf the pan sides.
* Deep fat fryer must be continuously monitored during use: overheated oil
can burst into flame.
* The hood should not be used by children or persons not instructed in its
correct use.
MAINTENANCE
* Proper maintenance of the range hood will assure proper performance of
the unit.
* Disconnect the hood from the main supply before carrying out any
maintenance work.
* Clean and/or replace aluminum grease filters and activated charcoal filters
after specified period of time.
* Clean the hood using a damp cloth and a neutral liquid detergent.
* DISPOSAL: Do not dispose this product as unsorted municipal waste.
Collection of such waste separately for special treatment is necessary.

3
WARNING!!
In certain circumstances electrical appliances may be a danger hazard.
* Do not check the status of the filters while the range hood is operating.
* Do not touch the light bulbs after appliance use.
* Do not disconnect the appliance with wet hands.
* Avoid free flame, as it is damaging for the filters and a fire hazard.
* Constantly check food frying. Overheated oil may become a fire hazard.
* Disconnect the electrical plug prior to any maintenance.
* Children don’t recognize the risks of electrical appliances. Therefore use or
keep the appliance only under supervision of adults and out of the reach
from children.
* Don’t use this product outdoors.
* This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction,
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
* There shall be adequate ventilation of the room when the range hood is
used at the same time as appliances burning gas or other fuels.
* There is a fire risk if cleaning is not carried out in accordance with
instructions.

4
CHARACTERISTICS
DIMENSIONS
INSTALLATION & USE
DESCRIPTION / CONNECTIONS
The hood may be installed in the Ducting or the Recalculating version.
Ducting version
The hood draws the cooking fumes saturated
with fumes and odor, through the grease filters
and expels it to the outside through an outlet
pipe. With this version the charcoal filters are
not required.
1. Decide where the ductwork will run between
the hood and the outside.
2. A straight, short duct run will allow the hood to perform most efficiently.
3. Long duct runs, elbows, and transitions will reduce the performance of
the hood. Use as few of them as possible. Larger ducting may be
required for best performance with longer duct runs.
4. The air must not be discharged into a flue that is used for exhausting
fumes from appliances burning gas or other fuels Regulations
concerning the discharge of air have to be followed. Check with the local
authority and building codes for exhaust ducting requirements.
5. Install a roof/wall cap. Connect round metal ductwork to cap and work
back towards hood location.

5
Recalculating version
The hood draws cooking fumes saturated with fumes and odor through the
grease filters and charcoal filters and returns
clean air into the room. For constant efficiency,
the charcoal filters must be replaced periodically.
Caution: No need for plastic or rigid metal
ducting.
1. Install the charcoal filter.
2. Please note that the air is re-circulated into
the room through the front vents.
Decide from the outset on the type of installation (recirculation or
ducting). For greater efficiency, we recommend you install the hood
in the ducting version.
Electrical Connection
* Electrical wiring must be done by a qualified person(s) in accordance with
all applicable codes and standards. Turn off electrical power at service
entrance before wiring.
* If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
* Do not use the plug and an extension cord other than the ones initially
supplied with the hood.
INSTALLATION
Before beginning installation, to better handle the hood, we advise removing
the filter.
Before fixing, the outlet exhaust duct for air evacuation to the outside must
be installed. Use an outlet exhaust duct with: - minimum indispensable
length; -Minimum possible bends
(maximum angle of bend: 90°); -certified
material (according to local, building & fire

6
regulations); and as smooth as possible inside. It is also advisable to avoid
any drastic changes in duct cross-section (recommended diameter:
125mm).
Decide on the position of the hole for the air outlet: The hole may be in the
wall or the ceiling, according to your requirements, but must be in vertical
line with your hood.
Select the type most suited to your needs and
proceed by mounting the air outlet adapter
(C)
Drill the hole in the wall for the air outlet (133 mm
diameter) referring to drawings here on the right
where the measurements for the various possibilities
are indicated.
Proceed with fixing the hood: Based on your
requirements, you can fit the hood on the wall or on a
wall unit of your kitchen. IMPORTANT: Respect the
distance between the hob and lower part of the hood which must be at least
650mm.
Fixing to the wall
1. Draw a line on the wall in vertical line with your
hob. Mark the 4 holes to be drilled in the wall,
respecting the distances indicated; Make the 4
holes and fit the 4 screw anchors provided.
Take 2 of the screws provided and insert them
in the topmost screw anchors without, however,
screwing them down completely. Hang the
hood on the 2 screws; Working from inside the
hood, tighten the 2 screws completely.
2. Now proceed with final fixing by fitting the

7
other 2 screws. Connect a flexible exhaust duct to the hood flange, using
a metal hose clamp. Tube and hose clamps are not provided.
3. Make the electrical connection.
Fitting under wall unit
1. Drill 4 holes in the wall unit, respecting the
distance indicated. Push the hood up against
the wall unit and insert the 4 screws operating
from inside the wall unit. Connect a flexible
tube to the hood flange, using a metal hose
clamp. Tube and hose clamps are not
provided.
2. Make the electrical connection.
Installation is now complete. We recommend you:
CHECK THAT THE DUCTING-RECIRCULATING
LEVER IS IN THE RIGHT POSITION: The lever
is found on the motor unit and must be positioned
on the symbol E in the case of installation in
ducting version.
·Also remember that the use of charcoal filter/s is
not necessary with the ducting version; if these are fitted, please remove
them.
Notice:
-Exhaust air must not be discharged into a flue which is used for exhausting
fumes from appliance burning gas or other fuels.
-If the instructions for installation for the gas hob specify a greater distance
than 650mm, this has to be taken into account.

8
-The regulations concerning the discharge of exhaust air have to be
followed.
OPERATION
The hood is operated using the push button on the front panel.
The light switch turns the lamps on and off.
The fan switch turns the fan on to three speed settings:
MAINTENANCE
GREASE FILTER
The grease filters should be cleaned frequently (every two months of
operation, or more frequently for heavy use). Use a warm detergent
solution.
Grease filters are washable.
LAMPS
This range hood requires one normal lamps (AC 230V, 40W Max)
Note: This manual covers several different models & the information for
each model may differ slightly