VonHaus 3000015 User manual

RUSTIC TV UNIT
3000015 - Instruction Manual
WITH 2 DRAWERS

CONTENTS
Safety
1
2
Components
3
4
5
6
Assembly (Step 1 & 2)
Assembly (Step 3 & 4)
Assembly (Step 5 & 6 & 7)
Hardware
Instructions
7
8
9
10
Cleaning & Warranty
Assembly (Step 8 & 9 & 10 )
Assembly (Step 11 & 12 & 13 & 14)
Assembly (Step 15 & 16 & 17)

WARNING
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
1
IMPORTANT SAFETY INSTRUCTIONS
Do not use the Rustic TV Unit with 2 Drawers for any purpose other than that for which it is designed.
This product is not a toy. Children should be supervised to ensure they do not play with the product.
CAUTION: The assembly pack contains small parts which pose a choking hazard to children and pets. Keep
children and pets clear at all times during assembly.
Locate the Rustic TV Unit with 2 Drawers in a suitable area where it will not be an obstruction.
Place on solid, even ground.
This Rustic TV Unit with 2 Drawers is water resistant but not waterproof any prolonged contact with
water can cause the wood to warp or damage the finish.
CAUTION: Do not place hot drinks directly onto the furniture.
WARNING! Never stand on, or rest on the product as this can cause damage or injury.
Do not overload the product as this may result in damage to the product or personal injury.
Do not exceed maximum weight capacity of 10kg .
Do not clean the product with any abrasive chemicals, solvents and detergents as this can damage the surface.
Periodically check the fittings and secure as necessary (every 3 months or as required). Re-tighten the fittings 1
week after first assembly.
Take care not to over tighten any fixings as this could damage the product.
Always assemble near to the area to be installed/placed.
Ensure you have sufficient space to assemble the product.
CAUTION: Do not use any power tools to assemble the product as this could cause damage to fixings and
panels.
Anti-Tip Safety Strap Information
It is recommended that furniture items above 75cm in height should be secured to a wall to prevent accidental
tipping.
Securing the Anti-Tip Strap.
1. Attach the Anti-Tip Strap to the back of the unit secure into place
2. Place the unit against the wall you wish to be located and mark the wall where the tip strap will be attached.
NOTE: it is recommended to attach the tip strap a little lower than the top and depending on location
(centre or either side)
3. Use the appropriate wall fitting to secure into place.
TOOLS REQUIRED: (NOT SUPPLIED).

HARDWARE
2

3
COMPONENTS

ASSEMBLY
4
STEP 1
STEP 2

5
ASSEMBLY
Plastic Release to seperate PLS Seperate before lnstallation
STEP 4
STEP 3

ASSEMBLY
STEP 5
6
STEP 6
STEP 7

ASSEMBLY
STEP 8
7
STEP 9
STEP 10

ASSEMBLY
8
STEP 11
STEP 12
STEP 13 STEP 14