VonHaus 3009001 User manual

COLONIAL LARGE
STORAGE UNIT
3009001 - Instruction Manual

CONTENTS
Safety Instructions 1
Hardware 2
Components 3
Assembly (Step 1) 4
Assembly (Step 2) 5
Assembly (Step 3) 6

Assembly (Step 4 & 5) 7
Assembly (Step 6 & 7) 8
Assembly (Step 8 & 9 & 10) 9
Assembly (Step 11 & 12) 10
Assembly (Step 13), Cleaning 11
Warranty 12

WARNING
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
1
IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS
Do not use the Large Storage Unit for any purpose other than that for which it is designed.
This product is not a toy. Children should be supervised to ensure they do not play with the product.
CAUTION:CAUTION: The assembly pack contains small parts which pose a choking hazard to children and pets. Keep
children and pets clear at all times during assembly.
Locate the Large Storage Unit in a suitable area where it will not be an obstruction. Place on solid, even
ground.
This Large Storage Unit is water resistant but not waterproof any prolonged contact with water can cause the
wood to warp or damage the finish.
CAUTION:CAUTION: Do not place hot drinks directly onto the furniture.
WARNING!WARNING! Never stand on, or rest on the product as this can cause damage or injury.
Do not overload the product as this may result in damage to the product or personal injury.
Do not exceed maximum weight capacity of 10kg .
Do not clean the product with any abrasive chemicals, solvents and detergents as this can damage the surface.
Periodically check the fittings and secure as necessary (every 3 months or as required). Re-tighten the fittings 1
week after first assembly.
Take care not to over tighten any fixings as this could damage the product.
Always assemble near to the area to be installed/placed.
Ensure you have sufficient space to assemble the product.
CAUTION: Do not use any power tools to assemble the product as this could cause damage to fixings and
panels.
Anti-Tip Safety Strap Information
It is recommended that furniture items above 75cm in height should be secured to a wall to prevent accidental
tipping.
Securing the Anti-Tip Strap.
1. Attach the Anti-Tip Strap to the back of the unit secure into place
2. Place the unit against the wall you wish to be located and mark the wall where the tip strap will be attached.
NOTE: it is recommended to attach the tip strap a little lower than the top and depending on location
(centre or either side)
3. Use the appropriate wall fitting to secure into place.
TOOLS REQUIRED:TOOLS REQUIRED: (NOT SUPPLIED).

H
AX20 BX20 CX36 DX9
EX2 G
JX1
FX18
KX19 LX23IX1
MX4
QX1
N O PX4 X1 X1
HARDWARE
X1

3
COMPONENTS
1X1
4X2
7X1
10 X4
14 X4
11 X4
16 X1 17 X815 X2
12 X4 13 X4
8X1 9X1
5X1 6X1
2X1 3X1

ASSEMBLY
A
F
1
2
17
A
STEP 1

5
D
I
H
J
E
D
ASSEMBLY
STEP 2
5
7
A
F
G

ASSEMBLY
STEP 3
F
A
3
6
17
M
D

X2
X4
M
M
D
A
C
K
D
15
16
14
STEP 5
STEP 4
3
6
8
7
ASSEMBLY