VonHaus 3009002 User manual

COLONIAL
UNDER
BASIN UNIT
3009002 - Instruction Manual

CONTENTS
Warnings 1
Components 2
Hardware 3
Assembly 4
Assembly 5

Assembly 6
Assembly 7
Cleaning & Maintenance, Troubleshooting Warranty 8

WARNING
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
1
IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS
The Colonial Under Basin Unit is intended for indoor use only.
Do not use the Colonial Under Basin Unit for any purpose other than that for which it is designed.
This product is not a toy. Children should be supervised to ensure they do not play with the product.
CAUTION:CAUTION: The assembly pack contains small parts which pose a choking hazard to children and pets. Keep
children and pets clear at all times during assembly.
Locate the Colonial Under Basin Unit in a suitable area where it will not be an obstruction. Place on solid, even
ground.
This Colonial Under Basin Unit is water resistant but not waterproof any prolonged contact with water can
cause the wood to warp or damage the finish.
CAUTION:CAUTION: Do not place hot drinks directly onto the furniture.
WARNING!WARNING! Never stand on, or rest on the product as this can cause damage or injury.
Do not overload the product as this may result in damage to the product or personal injury.
Do not exceed maximum weight capacity of 10kg .
Do not clean the product with any abrasive chemicals, solvents and detergents as this can damage the surface.
Periodically check the fittings and secure as necessary (every 3 months or as required). Re-tighten the fittings 1
week after first assembly.
Take care not to over tighten any fixings as this could damage the product.
Always assemble near to the area to be installed/placed.
Ensure you have sufficent space to assemble the product.
CAUTION: Do not use any power tools to assemble the product as this could cause damage to fixings and
panels.
TOOLS REQUIRED:TOOLS REQUIRED:
SCREWDRIVERS (NOT SUPPLIED).

COMPONENTS
HARDWARE
A B C D
E F G H
I J K
x14 x14 x16 x14
x2 x2 x10 x4
x2 x1 x4

ASSEMBLY
STEP 1
SIDE PANELS
STEP 2
SIDE PANELS
3
B
B
G
G
A
B
B
A
A
G
6
5
4
3

ASSEMBLY
STEP 3
BACK COVER
STEP 4
SHELF SUPPORTS
4
9
9
C
H
H
H
H

STEP 5
MIDDLE SHELF
STEP 6
DOOR PANELS
ASSEMBLY
5
H
H
7
E
1
2
D
I
F
F
F
K
K
K

ASSEMBLY
STEP 7
DOOR FITTING
1
2
K
K
K
K

ASSEMBLY
STEP 7
ATTACHING THE MAGNET LATCH
A
A
A
AB
B
J
DD
8
STEP 8
ATTACHING THE TOP PANEL
7