Vremi VRM010711N User manual

Electric Blanket
This Is A Manual.
You’re
Getting
Warmer

Electric Blanket · Table Of Contents · 3
Thank you for choosing our Electric Blanket.
Beforeusing your unit, please read this manual
carefully. Should you have questions, please contact
Customer Service at vremi.com/chat,
646-490-9904 or [e-mail].
Table Of Contents
Important Safety Instructions ·4
Blanket Features ·6
Operating Instructions ·7
Cleaning & Maintenance ·9
Troubleshooting ·10
Warranty Information ·11
In the event this product malfunctions, or you believe it is defective,
please contact Customer Service at vremi.com/chat,
646-490-9904 or [e-mail] and hold onto
the defective product (pending further instruction).
A defective product should be clearly marked or stored
where it cannot be used by mistake. Failure to keep
the product in its original quality from the time
of receipt may impede Vremi®’s ability to correct
any legitimate problem and may limit the extent
to which Vremi® may provide recourse.

4 · Important Safety Instructions · Electric Blanket Electric Blanket · Important Safety Instructions · 5
IMPORTANT SAFETY INSTRUCTIONS
· Never trap or pinch any of the electrical
cords in any way. Make sure the cords are
never rested between the mattress and
box springs.
· The heated area should always lie flat to
prevent overheating.
· If the plug does not fit into your outlet,
contact a qualified electrician.
· Be sure that the power supply is used only
on 120 V, 60Hz current supply.
· Make sure the cord from the Controller
to your heated product is connected and
locked tightly.
· You may use this electric product with any
sheets, mattress pads, or other blankets
but never in combination with any other
electric blankets or electric mattress pads.
· The warming product should never
be folded, balled up, or bunched in
any way when in use. This may result in
overheating and/or permanent wrinkling
of the fabric.
· Do not use with generators, power
converters, or inverters.
· Never use pins in and around the warming
product.
· Cats, dogs, and other pets should always
be kept away from the product, as a sharp
claw may result in damage to the heating
element.
· Always turn off the electric current
when the warming product is not in use,
either by turning off the Controller or
unplugging from the wall outlet.
· Wrapping of the cord around the controls
may damage the cord. Loop loosely when
storing.
· Do not use pins. They may damage the
electric wiring.
· Never iron your warming product.
· Never use dry cleaning fluid on this
product. Cleaning solvents may damage
the wiring insulation.
· Do not tuck in the wired area of this
bedding.
· Do not route electrical cords between the
mattress and box spring.
· Do not allow the cords to be pinched.
· Keep the control away from drafty areas
that may become damp or wet, such as an
open window.
· Be sure that this bedding is used on an
alternating-current supply circuit of the
proper voltage.
· Turn off or unplug when not in use.
Excessive heating may result from folding
bedding, other than a mattress, when in
actual use.
· If improper operation of this bedding is
observed, discontinue its use immediately,
and consult the manufacturer or the dealer
regarding its repair.
· Do not use with rocking chairs, recliners,
chairs with casters or wheels, or other
furniture subject to movement.
· Do not tuck the blanket or supply cord in a
sofa or other furniture. All portions of the
blanket or the controller should be visible
at all times.
· This electric blanket has a polarized plug
(one blade is wider than the other) as
a safety feature. This plug will fit into a
polarized outlet only one way. If the plug
does not fit fully into the outlet, reverse
the plug. If it still does not fit, contact a
qualified electrician.
· This product is not designed or intended
for use by children 12 years of age or
younger. Do not use this product with an
immobile person or anyone insensitive to
heat, such as a person with poor blood
circulation.
·Do not sit on the Blanket.
·Do not use while sleeping.
·Never position the Blanket
underneath the body.
·Do not fold the Blanket.
·Avoid sharp folds that may
damage the product.
Hot surfaces.
SAVE THESE INSTRUCTIONS
For Household Use Only
To reduce risks of burns, electric shock, fire, and personal injury, this product
must be used in accordance with the following instructions:
DANGER
DANGER DANGER

6 · Blanket Features · Electric Blanket Electric Blanket · Operating Instructions · 7
Blanket Features
1. Power Cord
2. Blanket Connector
3. Control Panel
4. Control Connector
1
3
4
2
Before each use, always inspect the product to ensure there is no damage to the Power
Cord, the Control Panel, and the Blanket.
1. Press the “On/Off“ button on the Control Panel. The Display will illuminate and all icons
will display. As a default, “85 °F” will display, indicating the Control is set to the lowest heat
level.“8h” will display, indicating the Control Panel is set to the 8 hours auto off.
2. To change your desired heat level, press the +button for a higher heat level or the
–button for a lower heat level. You can set it within 3 seconds after turning on, and “SET“
will appear for about 3 seconds, then it will display the real-time temperature of the pad.
TEMPERATURE
SELECTION INDICATOR HEAT UP ELAPSED TIME
Low 85°F 15 min
290°F 20 min
395°F 30 min
4100°F 40 min
5105°F 50 min
High 110 ° F 60 min
WARNING
1. Plug the Control Connector into the Blanket Connector
and make sure they are connected tightly. Do not connect
the connectors if the blanket is just washed. Make sure
both connectors are completely dry. ( Fig. 1)
2. Plug the product into a 120 V AC electrical outlet. Fig. 1
WARNING
Burns may occur even if you set the temperature to a low level.
Check your skin under the Blanket frequently.
Operating Instructions
PLUGGING IN YOUR BLANKET
TEMPERATURE SELECTION
as Level 6 as Level 3
DISPLAY OF HEAT LEVEL SETTINGS

8 · Operating Instructions · Electric Blanket Electric Blanket · Cleaning & Maintenance · 9
This Blanket will turn off after a set duration of time. You can set it at 1 hour, 2 hours,
3hours, 4 hours, 5 hours, 6 hours, 7 hours, and 8 hours.
1. After turning the Blanket on and selecting the desired heat setting, press the button
repeatedly until the desired amount of time is displayed. Time display will flash for
3seconds, and then gets steady.
2. When the Blanket is turned off, the auto off timer is reset to default settings (8 hours).
Follow Step1 to change the Auto Off settings.
1. Place the Blanket on top of your body. If the Blanket does not heat evenly, make sure
there are no folded areas.
2. Turn the product off by pressing the “On/Off“ button. Unplug it when not in use.
1. Machine Wash
Place textile portion without cords in the
washing machine. Machine wash on gentle or
delicate cycle.
2. Hand Wash
Washing your warming product by hand is
the best way to make it last. Wash your textile
separately by hand in lukewarm (100°F) water
using a small amount of mild laundry soap
or detergent. Gently work the textile up and
down. Do not rub or scrub. Rinse thoroughly in
cool water. Squeeze excess water out by hand;
never twist. Do not use a wringer.
1. Machine Dry
Put your Electric Blanket into a dryer on low heat and allow it to tumble until dry. Ensure that
the textile has enough room to tumble freely. If the product shrinks slightly in during
washing, while still damp, gently stretch until it returns to its original size.
2. Line Dry
You can line dry your Blanket by simply draping it over two parallel clothes lines or a shower
rod. The head and foot of the Blanket should both be facing down. Do not use clothes pins
that could pinch wires.
Store as you would for any other bedding, folded in a dry place.
WASHING INSTRUCTIONS
PRE-HEATING YOUR BLANKET
USING YOUR BLANKET
AUTO OFF SETTINGS
Cleaning & Maintenance
DRYING INSTRUCTIONS
STORAGE
WARNING
· Do not use commercial dryers at the laundromat. They may be extra hot and could
damage the wiring. Do not iron. Do not plug in until completely dry.
· If the Blanket gets damp by accident, please only use after it has fully dried.
WARNING
Never dry clean or use bleach.
Before washing, disconnect all
cords. Do not submerge cords or
control unit in water. ( Fig. 2)
WARNING
The Control Connector cannot be
covered when in use.
NOTE: The Maximum heating level that can be set is 110° F. The fastest way to heat
your Blanket is to set the product to a high heating level after turning it on. Once
desired temperature has been reached, set it to your preferred heating level. It is
recommended not to use the Blanket on a high heating level for too long.
IMPORTANT NOTE: The Control Panel displays the internal blanket temperature,
not the external blanket temperature, which will be lower than that displayed.
Fig. 2
Operating Instructions

10 · Troubleshooting · Electric Blanket
Troubleshooting
PROBLEM POSSIBLE CAUSES & SOLUTIONS
Blanket will not
turnon.
∙ Make sure that the Plug is plugged securely into
a 120 V / 60 Hz outlet.
∙ Make sure that the Connectors are connected and fully
inserted.
The Control Panel
displays “F2” error
code.
∙ The Control Connector and the Blanket Connector are
separated. Unplug the Blanket first, and then reconnect the
Connectors. Make sure they are connected securely and
tightly. Then plug in and re-start the Blanket.
Vremi® offers a 12-month warranty on all of our products purchased new and unused from
Vremi® LLC or an authorized reseller, with an original proof of purchase and where a defect
has arisen, wholly or substantially, as a result of faulty manufacturing, parts or workmanship
during the Warranty Period.
The warranty does not apply where damage is caused by other factors, including but
without limitation to: (a) normal wear and tear; (b) abuse, mishandling, accident or failure
to follow operating instructions; (c) exposure to liquid or infiltration of foreign particles;
(d) servicing or modification of the product other than by Vremi®.
These are our general terms for the warranty service, but we always urge our customers
to reach out to us with any issue, regardless of warranty terms. If you experience an issue
with a Vremi® product, please contact us at support@vremi. com, and we will do our best
toresolve it for you.
This product complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This product may not cause harmful interference and
(2) This product must accept any interference received,
including interference that may cause undesired operations.
We’re Here To Help:
Warranty Information
Drop Us A Line
RATING: 120 V AC, 60 Hz, 180 W, 1.5A, AC ONLY.
WARNING: Keep all plastic bags away from children.
vremi.com/chat
646-490-9904
[e-mail]
WARNING: This manual is to be used with all items
with the model numbers:
VRM010711N

vremi.com/chat [e-mail] 646-490-9904Questions?