WAC Lighting MODERN FORMS TL-1810 User manual

1Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
HARDWARE
INSTALLATION INSTRUCTION
1810 - Table Lamp
TL-1810
Allen Screw
Qty: 2 pcs + 1 Extra
M5X12 Nickel
Allen Screw
Qty: 1 pc
A1 B1
WARNING
- Read all instructions before installing.
CAUTION
- All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are
worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this xture.
CAUTION When handling the xture, do not apply pressure to the LEDs. Hold the xture by the base only.
AVERTISSEMENT
- Lisez toutes les instructions avant d’installer.
MISE EN GARDE
- Toutes les pièces doivent être utilisées tel qu’il est indiqué dans ces instructions. Ne remplacez pas les pièces, n’en laissez pas de côté
et ne les utilisez pas si elles sont usées ou brisées. Le non-respect de ces instructions peut annuler l’homologation ETL/CETL du
luminaire. MISE EN GARDE Ors de la manipulation de l’appareil, ne pas appliquer de pression à la LED, tenir l’appareil par la seule base.
ADVERTENCIA
- Lea y comprenda todas las instrucciones e ilustraciones por completo antes de proceder con el ensamblaje e insta lación de esta
lámpara.
PRECAUCIÓN
- Todas las piezas deben usarse como lo indican estas instrucciones. No reemplace las piezas, noomita piezas durante la instalación ni
utilice piezas gastadas o rotas. El incumplimiento de esta indicación podría invalidar la calicación
ETL/CETL esta lámpara. PRECAUCIÓN Al manipular el aparato, no aplique presión a los LED, mantenga el aparato en la base sólo.

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
1810 - Table Lamp
TL-1810
PREPARATION
1. Carefully unpack your new lamp, lay out all the parts on a clear area. Be careful not to lose any small parts.
2. Secure the base to the lamp body with Allen screw (A1) with Allen wrench (B1).
3. Connect connector cable to the power supply.
4. Plug into outlet.
5. This lamp features a touch dimmer.
To choose desired brightness:
1st tap - Turn On
2nd tap - Brighter
3rd tap - Max. Brightness
Switch
Allen Screw
Allen Wrench
Power Supply
Connector
Lamp Body
Base
A1
B1
FIG. 1