WAHL
HOME PRODUCTS
®
closest
cut
longest
cut
Quick Start Guide
Adding Attachment Guards
Removing
Attachment Guards
Blades
Power Screw
Soft Grip Sleeve
Cord
On/Off Switch
Fade Lever
Your New Clipper
Blend it!
Use for blending between different hair lengths.
The fade lever adds versatility to your clipper by
allowing you to gradually change the closeness of
your cut.
Up = closest
Down = longest
Goof- Proof!
Max Power!
Too Noisy?
Keep it Running Like New!
Helpful Hints
Use brush included to clean out excess hair on clipper and between blades (don’t clean with running water)
SAFETY FIRST! Please read instruction book first before using clipper
From underneath, lift
tab up to release
from blade.
1. Turn your clipper “ON”
2. Use the end of the cleaning brush or a
screwdriver to turn power screw in a CLOCKWISE
direction until you hear a clattering noise.
3. Then turn power screw in opposite direction
(COUNTER CLOCKWISE) until clattering stops.
Adjusting Power Screw for Max Power Setting
Haircutting Tips & Techniques
Section 2: Under the rim
of the head
Section 4: Top of the head
Section 1: The neckline
Section 3:The rim or side
©2018 part no: 92365-2101
v. 06.2018
(A) Oil blades as noted on this sheet.
(B) The power screw was adjusted for peak
efficiency before leaving the factory. However, if
voltage in your home is too high or low; the
clipper power screw may need adjustment.
Adjust Power Screw to Reduce Clipper Noise
(excessive clattering):
1. Peel back soft grip sleeve on right side of
clipper to expose power screw.
2. Turn your clipper “ON”
3. Use the
end of the detail brush
or a screwdriver to turn
power screw in a
COUNTER CLOCKWISE
direction until clatter
goes away.
Align guard onto blade then press down on
guard where guard number is located until you
hear a snap.
Haircutting Tips & Techniques
When you cut your hair, you should visualize
the head as if it were divided into four
sections. Image above shows the different
sections. Using proper techniques when
moving from one section to the next will help
you blend the sections together for profes-
sional looking results. See instruction book
for more tips.
The blades of your new
clipper and trimmer
should be oiled every
few haircuts. For best
results, place three
drops on front of the
blades and one drop on
each side of blade as
shown.
Use only the Wahl Clipper Oil included in the
pack. Do not use hair oil, grease or any oil mixed
with kerosene or any solvent.
