WALDNER Lisa User manual

USER GUIDE &
CERTIFICATE OF WARRANTY
LISA

GETREIDEMÜHLEN WALDNER BIOTECH GMBH
Kärntnerstraße 62, A-9900 Lienz/Osttirol
[phone], offi[email protected]
www.waldner-biotech.at
design: aberjung.com
photos: ramonawaldner.com

We trust in domestic
woods and handcraft 100 %
made in Tyrol.
ELECTRIC FLAKER LISA

GENERAL
REQUIREMENTS
1
ELECTRIC FLAKER LISA
Device can be used by persons with reduced physical, sen-
sory or mental capabilities or lack of experience and/or
knowledge if they have been given supervision or instruction
concerning the use of the appliance in a safe way and under-
stand the hazards involved. Children should not play with the
appliance.
When not supervised and prior to the assembling and disas-
sembling or cleaning the device has to be disconnected from
the power supply. The device may not be used by children.
Keep device and power cable away from children.
!ATTENTION: Misuse can cause injuries.
SAFETY: Never immerse the device into water. Only au-
thorized customer service is allowed to perform repairs
using original parts and spare parts. If the power ca-
ble of this device is damaged, it must be replaced by
the manufacturer or its Customer service or a similarly
qualified person in order to avoid any danger.

ELECTRIC FLAKER LISA –
TECHNICAL DATA
2
Overload protection with thermal sensors
Certified TÜV quality
Type of wood
Grain crusher output
Dimensions H / D
Weight
Volt/Hertz/Watt
larch, stone pine
110g/min
29 / 15,5 cm
5,5 kg
230 / 50 / 120
KG
ELECTRIC FLAKER LISA

COMPONENTS
1
2
5
6
1. protective cover flaker
(removable)
2. hopper
3. squeezer (not visible)
4. output flakes
5. Power button ON / OFF
6. Supply line power plug (not visible)
3
3
4
ELECTRIC FLAKER LISA

4
WHAT TO FLAKE
ELECTRIC FLAKER LISA
GRAINS
Oat, spelt, wheat, millet, rye, etc
GRAINS AND SEEDS
sesame, flax seed, etc.
SPICES AND SALTS
fennel, kummel, cilantro, etc.
NOT SUITABLE:
corn, rice, chickpea & soya
!

5
INITIAL
OPERATION
ELECTRIC FLAKER LISA
INITIAL OPERATION
1. Place flaker on a ground surface. Attention: Never place
the flaker on a hot surface (eg stovetop)
2. Check if supply voltage corresponds to the required voltage
for the device
3. Plug power plug into socket.
4. Press power switch to 1.
!NOTE: Efficiency & result of the grinding depend on the
quality of the flaker material. The drier the flaker mate-
rial, the higher the efficiency.

6
2. Place a vessel
2
3
3. Switch on
1
1. Fill flaking material,
e.g. oat into the hopper
3
4. Switch off after use
ELECTRIC FLAKER LISA

7
... ALREADY DA VINCI CONSIDERED
HER AS A MASTERPIECE