Walker Edison D51L29 User manual

Assembly Instructions

Parts List
7
6
6
2
2
10
4
4
5
8
9
8

Component List
1 Leg 4 pcs
2 Upper crossbar 2 pcs
3 Lower crossbar 2 pcs
5 Corner frame 1 pc
6 Upper crossbar 2 pcs
7 Keyboard tray frame 1 pc
8 Glass 2 pcs
9 Corner glass 1 pc
4 Keyboard tray support 2 pcs
10 Keyboard tray glass 1 pc
11 CPU stand 1 pc

Hardware List
Short bolt
Medium bolt
Long bolt
Rubber suction cup
Foot
*Note: This piece comes preassembled for
shipping purposes and must be disassembled
to complete the desk assembly.
A Phillips head screwdriver is required for assembly
(not included)

Screw feet (F) into legs (1) and CPU stand (11).
Attach upper crossbars (2) to keyboard tray supports (4) using medium bolts (C). Note the proper alignment
of all bolt holes as shown above. Tighten medium bolts (C) with wrench (A).
1
11
1
1
1
A
4
C
2
4
2

Attach upper crossbars (2) and lower crossbar (3) to leg (1) using medium bolts (C). Tighten medium bolts
(C) with wrench (A).
Attach leg (1) and corner frame (5) to the assembly from the previous step using long bolts (D). Ensure that
the glass supports of corner frame (5) are facing up (reference Steps 8 and 9). Secure leg (1) to lower
crossbar (3) using medium bolts (C). Tighten all bolts with wrench (A).
2
2
3
1
C
C
C
A
3
C
5
D
D

Tray arm
Tray bracket
Disassemble keyboard tray slider (G) by sliding the tray arm and tray bracket apart. Depress the small
lever of the tray bracket and carefully pull the two pieces apart. Repeat this process for both keyboard tray
sliders (G).
Attach the tray arms of keyboard tray sliders (G) to keyboard tray supports (4) using short bolts (B). Ensure
that the open end of each tray arm is near the front of the desk. Tighten short bolts (B) with a screwdriver.
Attach leg (1) and crossbars (6) to corner frame (5) using long bolts (D). Attach lower crossbar (3) to leg (1)
using medium bolts (C). Tighten all bolts (C,D) with wrench (A).
4
4
B
A
C
DD
6
6
3
1
5

6
6
3
A
C
1
C
C
Attach leg (1) to upper crossbars (6) and lower crossbar (3) using medium bolts (C). Tighten medium bolts
(C) with wrench (A).
B
B
B
B
7
Attach the tray brackets of keyboard tray sliders (G) to keyboard tray frame (7) using short bolts (B).
Ensure that the open end of each tray bracket is near the back of keyboard tray frame (7). Tighten short
bolts (B) with a screwdriver.
Tray bracket
Tray bracket

Carefully slide keyboard tray frame (7) into place. The tray brackets attached to keyboard tray frame (7)
will slide into the tray arms attached to the keyboard tray supports (4). Insert rubber suction cups (E) into
the desk frame as shown above.
E
E
Tray arm
Tray bracket
7
4
4
Carefully lay keyboard tray glass (10) in place and gently press to secure. Carefully lay glass (8) and
corner glass (9) in place and gently press to secure.
8 8
9
10

10