Walker Edison W52SOI2D User manual

General Assembly Guidelines
 
 
 
 

 
 

二丿




 
 
勹
 
 

Using bolt (A) attach part (12,13) onto part (2) to secure with hex key (P).

Using bolt (A) attach part (7) onto part (1) with hex key (P).

Using bolt (A) to attach part (15) onto part (6) to secure with hex key (P) .

Using bolt (C) attach part (14) onto part (1) to secure with hex key (P), put door
stopper (F) attach part (1), using screw (G) onto poor stopper with Philips screwdriver
as diagram.

using bolt A attach part (3) onto part (14) to secure with hex key (P) as diagram.

Using bolt (B) attach part (12,13) onto part (7) to insert part (12,13) with hex key (P) as diagram.

Using bolt (B) attach part (15) onto part (12,13,14), secure with hex key per diagram.

Insert screw (D) onto part (6) to connect part (3) by Philips head screwdriver per diagram.

Attach part (11) onto part (15,1) ,using bolt (A,B) secure with hex key (P) per diagram.

Place plastic cap (M,N) onto part (15) as per diagram.

Insert screw (L) onto part ( 8,9,10,18 ) with Philips head screwdriver .

Insert shelf support pin (E) onto part (2,3).

Put part (4,5) onto cabinet as per diagram.

Attach handle (H) onto ( 16,17) insert bolt (J) secure with Philips head screwdriver as
per diagram.

Attach part (16) onto part (12) ,insert screw (K) with Philip head screwdriver as diagram.

Using screw (K) attach part (17) onto part (14) to secure with Philips head screwdriver as diagram.