Walker Edison TW485PC User manual

Carefully slide table legs (2) into place and attach to table top (1) using flat washers (C), spring washers (B)
and bolts (A). Tighten bolts (A) with wrench (H).

Insert dowels (G) into the dowel holes in chair back (3). Attach chair back (3) to leg (6) using dowels as guides.
Repeat this step for all chairs.
Secure chair back (3) to leg (6) using bolt (D) and bend washer (E). Tighten bolt (D) with wrench (J). Repeat
this step for all chairs.

Insert dowels (G) into the dowel holes in slat (4). Insert slat (4) into leg (6) using dowels as guides. Repeat
this step for all chairs.
Secure slat (4) to leg (6) using bolt (D) and bend washer (E). Tighten bolt (D) with wrench (J). Repeat this step
for all chairs.

Attach leg (5) to the chair assembly using dowels and slat (4) as guides. Repeat this step for all chairs.
Secure leg (5) to chair back (3) and slat (4) using bolts (D) and bend washer (E). Tighten bolts (D) with
wrench (J). Repeat this step for all chairs.

Carefully place chair assembly upside down on a flat surface and place chair seat (7) underneath as shown
above. Secure chair seat (7) to the chair assembly using screw (F). Repeat this step for all chairs. *Note that
the pre-drilled holes of chair seat (7) are for manufacturing purposes only. Screws (F) will be screwed directly
into the solid wood of chair seat (7) at slat (4) and legs (5,6).