Walker Edison W58CSP-MT User manual

ITEM # : W58CSP-MT
Assembly Instructions










  
 

Copyright © 2012, by Walker Edison Furniture Co., LLC. All rights reseed. P.1

Insert dowels (A) into panel (2). Screw cam bolts (B) into panels (1,2).
Insert dowels (A) into panel (4,15) and slats (6,7). Screw cam bolts (B) into slat (5).

Insert dowels (A) into legs (11,12,13,14) and panels (3). Screw cam bolts (B) into
legs (11,12,13,14).
Attach legs (11,13) to panel (3) using cam bolts and dowels as guides. Insert cam locks (C)
into panel (3) and tighten with a screwdriver.

Attach legs (12,14) to second panel (3) using cam bolts and dowels as guides. Insert cam
locks (C) into panel (3) and tighten with a screwdriver.
Attach slat (7) to panel (2) using cam bolt and dowels as guides. Insert cam lock (C) into
slat (7) and tighten with a screwdriver.

Attach support leg (8) to panel (2) using bolts (D). Tighten bolts (D) with wrench (H).
Attach slat (5) to panel (4) using cam bolts and dowel as guides. Insert cam locks (C) into
panel (4) and tighten with a screwdriver.

Attach panel (4,15) to panel (2) using bolts (D). Tighten bolts (D) with wrench (H).
Attach slat (6) to slat (5) using dowel as guide.

Attach panel (3) with legs (11,13) to the assembly from the previous step using cam bolts and
dowels as guides. Insert cam locks (C) into panel (2) and slat (6) and tighten with a screwdriver.
Attach second panel (3) with legs (12,14) to the assembly from the previous step using cam
bolts and dowels as guides. Insert cam locks (C) into panel (2) and slat (6) and tighten with
a screwdriver.

Carefully slide panels (10) into place along the back of the assembly.
Carefully attach panel (1) to the assembly using cam bolts and dowels as guides. Insert cam
locks (C) into the assembly as shown above and tighten with a screwdriver.

Secure panels (10) with plastic wedges (E) and screws (F).
Cover all visible cam locks with stickers (K) as desired.

Insert shelf support pins (G) into the assembly at desired shelf heights. Carefully place
shelves (9) on shelf support pins (G).
Completed stand assembly. The following steps show the assembly and attachment of the
TV mount.

Attach lateral support bar (b) to upright support bar (a) using bolts (e) and washers (f).
Attach support brackets (d) to upright support bar (a) using bolts (e) and washers (f).
Slide mounting bars (c) onto lateral support bar (b). Secure mounting bars (c) by screwing
adjustment knobs (g) into place.

Attach TV mount to stand assembly using bolts (e) and washers (f).
Tighten bolts (e) with wrench (h).