Walker Edison W70CSP User manual

ITEM # : W70CSP
Assembly Instructions
  
 
Revised 03/2017
Copyright © 2012, by Walker Edison Furniture Co., LLC. All rights reseed. P.1

Insert dowels (A) into panel (2). Screw cam bolts (B) into panels (1,2).
Insert dowels (A) into slats (6,7). Screw cam bolts (B) into slats (15).

Insert dowels (A) into panels (3,4,5).
Insert dowels (A) into legs (11,12,13,14) . Screw cam bolts (B) into legs (11,12,13,14).

Attach legs (11,13) to panel (3) using cam bolts and dowels as guides. Insert cam locks (C)
into panel (3) and tighten with a screwdriver.
Attach legs (12,14) to second panel (3) using cam bolts and dowels as guides. Insert cam
locks (C) into panel (3) and tighten with a screwdriver.

Attach slat (7) to panel (2) using cam bolt as guides. Insert cam lock (C) into slat (7) and tighten
with a screwdriver. Secure screw (L) to slat (7) to panel (2).
Attach support legs (8) to panel (2) using bolts (D). Tighten bolts (D) with wrench (H).

Attach slat (15) to panel (4) using cam bolts and dowel as guides. Insert cam locks (C) into
panel (4) and tighten with a screwdriver.
Attach slat (15) to panel (5) using cam bolts and dowel as guides. Insert cam locks (C) into
panel (5) and tighten with a screwdriver.

Attach panel (4,5) to panel (2) using bolts (D). Tighten bolts (D) with wrench (H).
Attach slat (6) to slats (15) using dowel as guide.

Attach panel (3) with legs (12,14) to the assembly from the previous step using cam bolts and
dowels as guides. Insert cam locks (C) into panel (2) and slat (6) and tighten with a screwdriver.
Attach second panel (3) with legs (11,13) to the assembly from the previous step using cam
bolts and dowels as guides. Insert cam locks (C) into panel (2) and slat (6) and tighten with
a screwdriver.

Carefully slide panels (10) into place along the back of the assembly.
Carefully attach panel (1) to the assembly using cam bolts and dowels as guides. Insert cam
locks (C) into the assembly as shown above and tighten with a screwdriver. Secure screw (L)
to slat (6) to panel (1).

Secure panels (10) with plastic wedges (E) and screws (F).
Cover all visible cam locks with stickers (K) as desired.

Insert shelf support pins (G) into the assembly at desired shelf heights. Carefully place
shelves (9) on shelf support pins (G).