Warmington Southern Series User manual

Southern Series Door Glass Fitment
No: 1 No: 2
NOTE: Door Glass is not covered by Warranty
The Southern Series Door Glass is a special heat
resistance glass designed for use in Fires.
The glass can be replaced with the door still fitted to the Fire.
Remove the cap screws & retainers on the sides of the door that
hold the glass in position, then loosen the cap screws & bottom
retainers enough to be able to remove glass.
Tools - required but not supplied:
3mm Allen Key 1 x
No: 3
Remove the Glass. The bottom retainers should
still be in position & loosened enough to do so.
No: 4
Ensure that both glass rope and surfaces are clean before
replacing with the new glass.

No: 5
Place the new glass into the door at the bottom
and push against glass rope. Nip up bottom cap
screws with a 3mm Allen Key to hold glass in
place.
Fit the side retainers back onto the door with the cap screws. Nip up
cap screws ensuring not to over tighten as this may crack/break the
glass.
No: 6
IMPORTANT: DO NOT OVER TIGHTEN AS GLASS MAY CRACK/BREAK.