Wasserstein Solar Panel for Blink Video Doorbell User manual

Solar Panel for Blink
Video Doorbell
USER MANUAL

In the Box
3 x screws 3 x wall anchors
1 x solar panel mount
1 x solar panel
Page 1
1 x back plate
Safety Information
• Disassembling the solar panel is not recommended as it may cause
damage to internal components. The solar panel may not function
properly after disassembly.
• Do NOT leave bare wires exposed.
Pre-Installation
1. Make sure your solar panel has been charged in direct sunlight for
at least 10 hours.
2. Remove any previously installed doorbell, mount, or backplate.

Page 2
Mounting the Solar Panel
Mount your device directly onto wood using the screws provided. If you
are mounting onto brick, concrete, or stucco, mark the holes using the
bracket for guidance. Then, drill the holes, insert the anchors, and screw
the mount to the wall.
Installation
1. Use the key that comes with your Blink Video Doorbell to remove the
backplate.

Page 3
2. Remove any AA batteries.
3. Attach the wires to the new backplate. Connect the black wire to the left
screw and the red wire to the right screw. Guide the wires through the
opening at the bottom.
BLACK RED

Page 4
4. Mount the new backplate to the wall using the two anchors and screws
provided.
5. Align the top and bottom of the front of the doorbell with the top of the
backplate at an angle so the hooks align. Press the doorbell flush against
the backplate firmly and pull straight down until you hear and feel a slight
click to confirm it is secure. After the doorbell is locked securely, you should
see a red LED light flashing which indicates it is seeking connection.
If there is no red LED light flashing after you locked the doorbell, please
detach the doorbell and re-install again. Or, make sure you have charged
the solar panel for 10 hours before installation.

Page 5
Detaching the Doorbell
1. Use the key the comes with Blink Video doorbell.
In case you need to remove the doorbell from the backplate.
4. Put the key into the opening at the base of the Blink Video Doorbell.

Page 6
3. Lift, or pull the key "toward" you while you move the doorbell up to unseat
the hooks and seperate from the backplate.
Important Tips
The solar panel's energy output depends on sunlight exposure, weather
conditions, etc. To maximize the energy output, remember to do the
following:
• Before installing your doorbell, charge the solar panel for at least
10 hours under direct sunlight.
• Install your solar panel in an area that receives maximum sunlight.
• Clean the surface of the solar panel regularly to remove and dust or
dirt that could affect its energy conversion.
Troubleshooting
1. Unplug and re-insert both ends of the solar panel charging cable.
2. Make sure that your solar panel is pointed toward the sun and is not
obstructed by trees, buildings, or other obstacles.

Specifications
Material:
Power:
Output Voltage:
Solar panel size:
Cable length:
ABS + PC
2 W
3 V
7.87 x 5.6 x 0.7 in (200 x 142 x 13 mm)
13.1 ft (4 m)
Get More Support
Scan the QR code below or email us at [email protected].
Blink Video Doorbell is not included.
Blink Video Doorbell is a trademark of Immedia Semiconductor Inc.
Wasserstein is not affiliated with Immedia Semiconductor Inc.
Wasserstein is a trademark of Dropcases Ltd. Made in China
www.wasserstein-home.com