Wasserstein Blink Doorbell Solar Panel User manual

Blink Doorbell Solar Panel
USER MANUAL

In the Box
3 x screws 3 x wall anchors
1 x solar panel mount
1 x solar panel
(with micro USB cable)
Page 1
1 x back plate
Need help? Send us an email at: [email protected]

Safety Information
• Disassembling the solar panel is not recommended as it may cause
damage to internal components. The solar panel may not function
properly after disassembly.
• Do NOT leave bare wires exposed.
Pre-Installation
1. Make sure your solar panel has been charged in direct sunlight for
at least 10 hours.
2. Remove any previously installed doorbell, mount, or backplate.
Page 2
Mounting the Solar Panel
You can mount your device directly onto wood using the screws provided.
If you are mounting onto brick, concrete, or stucco, mark the holes first
using the bracket, then drill the holes and insert the anchors before
screwing the mount into the wall.

Page 3
2. Mount our backplate on the wall by the two anchors and two screws
provided.
Installation
1. Attach the wires to the back of your doorbell. The red wire connects to the
right screw. The black wire connects to the left screw.

Page 4
4. Remove any AA batteries from the Blink doorbell.
3. Use the key that comes with your Blink doorbell to remove the backplate.

Page 5
6. Push the doorbell down gently and it will snap onto the backplate.
5. Attach the new backplate to the Blink doorbell.

Important Tips
The solar panel's energy output depends on sunlight exposure, weather
conditions, etc. To maximize the energy output, remember to do the
following:
Troubleshooting
1. Unplug and re-insert both ends of the solar panel charging cable.
2. Make sure that your solar panel is pointed toward the sun and is not
obstructed by trees, buildings, or other obstacles.
• Before installing your doorbell, charge the solar panel for at least
10 hours.
• Install your solar panel in an area that receives maximum sunlight.
• Clean the surface of the solar panel regularly to remove and dust or
dirt that could affect its energy conversion.
Page 6
Specifications
Material:
Power:
Output Voltage:
Solar panel size:
Cable length:
ABS + PC
2 W
3 V
7.87 x 5.6 x 0.7 in (200 x 142 x 13 mm)
13.1 ft (4 m)

Get More Support
Blink Doorbell is not included.
Wasserstein is not affiliated with Immedia Semiconductor Inc.
Wasserstein is a trademark of Dropcases Ltd.
Blink Outdoor is a trademark of Immedia Semiconductor Inc.
Blink Doorbell is a trademark of Immedia Semiconductor Inc.
Scan the QR code below or email us at [email protected].
Made in China
www.wasserstein-home.com