The Door/Window Sensor can be
installed on doors, windows and
any other objects that open and
close. The sensor transmits signal
to the control panel when the two
parts are moved away from each
other. Tamper protection ensures
that any sabotage attempts will
result in alarm activation.
Working Status:
Installation:
Tamper Alarm: Once intruder attempts to move the sensor, the control
panel will send tamper alarm message to user at the first time.
LED flashes once：
Door or window is opened, and the transmitter sends signal
to the control panel. Or tamper alarm is triggered.
LED flashes once per 3 seconds :
Low battery indication.
If it's in low battery state, please replace it immediately.
Features:
It will cause an immediate alarm if the magnet
depart from the transmitter more than 2cm in
arming state.
<1cm
1. Magnet
2. Tamper Switch
3. Zone Jumper
4. LED Indicator
5. Reed
6. Battery Compartment
1
2
6
3
4
5
4
Recommended installation for
gap between moving part and frame
1
3
Vertical Installation
Horizontal Installation
5
1. Open the back cover of the sensor, pull out the battery tab and
check the battery is fitted properly.
2. Ensure the area that the sensor will be located is clean and free
from dust and moisture. Avoid mounting the sensor in areas with
lots of metal or electrical wiring.
3. Use the adhesive strip to carefully mount the sensor on to the
door/window frame.
4. Mount the magnet on to the door/ window, no more than 1cm
from the sensor.
