WatchNet WAR-BLU-HITKEY User manual

Proximity Card and Keypad Bluetooth Reader WAR-BLU-HITKEY
Quick Start Guide
(1) Introduction
WatchNET Access’s WAR-BLU-HITKEY are a mobile smartphone access control ID solution. Based upon the proven
contactless digital radio frequency identification (RFID) platform, the readers interface with a wide range of
electronic access control systems by complying with either the legacy Wiegand equipment or the latest bi-directional
Open Supervised Device Protocol (OSDP). In addition to traditional proximity credentials, such as clamshell cards
and key tags, the platform also offers the option of mobile access credentials loaded on Bluetooth Low Energy (BLE)
enabled smartphones. This allows the smartphone to function as a contactless electronic access control credential.
(2) Wiring
Color
Function
Panel Input
Red
7-12VDC
+12
Brown
Blue LED
LED
Green
Data 0
D0
White
Data 1
D1
Black
Ground
GND
Blue
Buzzer
BUZ
Notes: Default Wiegand Output is 26bit, Access control System support 24-72 bit formats
(3) Cable Requirements
22 AWG 7 Strand Bare Copper; 3 Individual Twisted Pairs Overall Foil with TC Drain & PVC Jacket
(4) Wiegand Outputs
Supports 26 and 34 Wiegand bit format
(5) Card Technology Supported
HID Card and Pin Technology
(6) Power
Reader can be powered by the access panel.
(7) Powering up Reader
1. When Reader is powered up reader will beep 1-time and blue LED will turn on.
2. When presenting a card that is not registered on the system, reader will beep 3-times with a blinking LED
of color Green.
3. When presenting a card that is registered on the system, reader will beep 1-time and Blue LED will change
to Green for 5 seconds and will go back to blue as standby.

(8) Troubleshooting
If the reader does not recognize a card or tag or does not turn on, please refer to below table
Possible causes
Solutions
Incorrect cabling
Verify wiring, see (2) for proper wiring
Reader did not beep when card is presented
Verify if card technology is supported
Reader beeps but no card events showing
Verify wiegand format of the card from 24-72 bit
format
Card number did not match the card’s number printed
from the card events
Make sure gray wire is not touching any wires or not
grounded to any wire, grounding gray wire will change
wiegand to 34 bit
Note: if any solutions above did not work please contact WatchNET Access Technical Support phone number
[phone] or visit our website @ www.watchnetaccess.com
All Logos & trade marks represent the registered users only. All right reserver.
All product specifications on this brochure are subject to change without notice.
CANADA: USA:
351 Ferrier Street Unit 5 171 Cooper Ave. Suite 110
Markham, Ontario L3R 5Z2 Tonawanda, NY 14150 USA
Toll Free: 1-866-843-6865 Toll Free: 1-855-404-3193
Tel: [phone] Local: 1-716-877-7277
Fax: [phone] Fax: [phone]
INDIA: UAE:
RZ-2, Ground Floor Kapashera P O Box No. 126312
Opp Kapashera Police Station Suite 703, Oxford Tower
New Delhi-110037 Dubai, UAE
Tell: [phone] Tel: [phone]
Mobile: [phone] Fax: [phone]
Hong Kong
Unit 04, 7/F Bright Way Tower
#33 Mong Kok Road
Kowlon, HK
Tel: [phone] [e-mail]
Fax: [phone] www.watchnetaccess.com