Watermark SH-35WF User manual

1
2
3
4
5
8
6
7
9
No.
1 Mounting Screw
2 Shower head (A)
3 Shower head (B)
4 Mounting Guide
5 Mounting Plate
6 Lock Nut
7 Washer
8 Shower Nipple
9 Wall Mount / Toggle Screw
Note: The shower head/spout is approximately 11 lbs
Component Quantity
2
1
1
1
1
2
2
1
2
Installation Guide for
SH-35WF, 35-WBSWF (AKA TBSPT-35WF)
350 Dewitt Avenue, Brooklyn, NY 11207 USA T: 718.257.2800 F: 718.257.2144 E: info@ watermark-designs.com

6 3/4'' Center to Center
Mounting Plate
Wall mount / Toggle Screws
Shower / Spout Nipple
1/2'' NPT MALE
Mounting Guide
WALL
2A. Align the mounting plate to the wall using the mounting guide and
position it as desired.
(Note: Position of mounting guide will dictate the orientation of the
shower head/spout)
2B. Once the desired orientation is established, mark the points in which
the holes for the wall mount screws will be located
(Note: The wall mount screw hole dimensions shown on the left figure
indicates center to center)
1A. Detach the mounting plate from the backside of the shower head/
spout by
unscrewing the two allen screws (mounting screws) located on
the bottom side of shower head/spout B (refer to parts list view)
1B. Connect the shower nipple to the supply line, followed by the
mounting guide.

3A. Drill wall with a hole size of 21/64'' with a maximum
depth of 1 11/32''. This depth will allow the lock nut to fasten
the mounting plate until it braces the wall.
See below for detailed diagram
3B. Once the hole has been drilled, remove the mounting plate
from the wall to insert the wall mount screws into the wall.
3C. Re-attach the mounting plate to the wall with the
wall mount screws and mounting guide properly aligned.
3D. Fasten mounting plate to the wall with the washers
and lock nut.

Wall
11/32''
Mounting Plate
Washer / Lock Nut
MIN. Depth of Hole 1 11/32''
Wall Mount / Toggle Screw Application
4A. After securing the mounting plate onto
the wall, remove the mounting
guide from the shower head/spout nipple.
4B. Mount the shower head/spout onto the mounting
plate and secure the two parts together with the
mounting screws.
Mounting Screws
Wall Mount Screw

9 7/8"
5 3/8''
6 3/4"
1/2-14 NPT
2 3/8"
3/4"
5/8"
1/4"
Approximate Weight: 11 lbs
SCALE: 2:1
REV: 6/19/2013
Meets the applicable requirements of ASME A112.18.1-2005/CSA B125.1-05, entitled “Plumbing Supply Fittings”
350 Dewitt Ave Brooklyn NY 11207 I t: 718-257-2800 I f: 718-257-2144 I e: [email protected] I www.watermark-designs.com
SH-35WF
2
Lavatory Widespread