Waterpik Waterflosser WP-100 User manual

3 4
1 2
Replace
Fill
High
Low
Pause
NO
Gap
Insert
Remove the reservoir from
base and fill with lukewarm
water.
Replace the reservoir onto
the base, PRESSING DOWN
FIRMLY to ensure full seating.
For first time
users, adjust
pressure control
to lowest position.
Gradually increase
pressure to your liking.
Prior to Very First Use of Unit, Prime Unit:
Set pressure control dial on base to high, point
the handle and tip into sink. Turn unit ON until
water flows from the tip, turn unit OFF.
You can temporarily stop
water flow by pressing
the pause button on
the handle.
continued on back
Press tip firmly into
handle. When tip is
properly inserted there
should be no gap
between handle and
colored tip ring.
This device is compatible with a voltage system of 240V, 50Hz. Do not plug this device into a voltage system that is different.
Adjust Pressure and Pause Control:
Select and Insert Tip:Prepare the Reservoir:
Prime Unit (First Time Use Only):
Model WP-100
M
od
QUICK START GUIDE

5
6 7
ON
OFF
Remove
Tip
Eject
Button
Pause
Lean over sink and close lips
enough to prevent splashing,
while still allowing water to
flow from mouth into the sink.
Turn unit ON.
Always place tip in mouth
before turning unit on.
20013668-F AB
Using your Waterpik®Water Flosser:
Technique Tips for Best Results:
Push the tip eject button on the
handle. The control knob will rise,
releasing the tip. Remove the tip.
Caution: Do not press tip eject
button while unit is running.
Tip Removal:
www.waterpik.com
©2013 Water Pik, Inc.
Aim the water stream just above the
gumline at a 90 degree angle.
Starting with the back teeth, follow the
gumline and pause briefly between teeth.
Continue until all areas around and
between teeth have been cleaned.
Always PAUSE
or turn unit OFF
before removing
tip from mouth.