Waterpik Waterflosser WP-70 User manual

4
Insert
2
Pause
3
1
High
Low
Fill
Replace
No Gap
Press tip firmly into handle. When tip
is properly inserted there should beno
gap between control knob and tip.
Prior to Very First Use of Unit: Set pressure
control slide switch on handle to high,point the
tip into sink. Turn unit ON until water flows from
the tip, turn unit OFF.
For first time users, adjust pressure
control to lowest position. Gradually
increase pressure as you prefer.
Prepare the Reservoir:
Prime Unit (First Time Use Only): Adjust Pressure and Pause Control:
Remove the reservoir from base
and fill withlukewarm water.
Replace the reservoir
onto the base, PRESSING
DOWN FIRMLY
.
You can temporarily stop water flow by
pressing thepausebutton onthe handle.
QUICK START GUIDE
Select and Insert Tip:
continued on back
Model WP-70
This device is only compatible with a voltage system of 220-230VAC, 50Hz.
Do not plug thisdevice into a voltage system that isdifferent.

6 7
Technique Tips for Best Results: Tip Removal:
Always place tip in mouth before turning uniton.
ON
5On/O Procedure:
Remove
Aim the tip just above the gumline
at a 90 degree angle.
Pointer l’embout juste au-dessus de la ligne
gingivale à un angle de 90 degrés.
Lean over sink and close lips enough to prevent splashing,
while still allowing water to flow from mouth into the sink.
Turn unit ON.
Always PAUSEor turn unit OFFbefore removing tip from mouth.
20018211-F AA
Water Pik, Inc.
1730 East Prospect Road, Fort Collins, CO 80553-0001 USA ©2013 Water Pik, Inc.
To remove tip,
simultaneously hold
control knob down
and lift tip up.
Starting with the back
teeth, follow the
gumline and pause
briefly between teeth.
Continue until all areas around and
between teeth have been cleaned.