WaterRower WOODEN DUAL RAIL Installation instructions

1
DISASSEMBLY INSTRUCTIONS: WOODEN DUAL RAIL WATERROWER
PREP DRAIN THE WATER FROM YOUR TANK
PREP WHAT YOU’LL NEED...
Place a plastic bag over the tank opening and insert tank stopper over the plastic
bag.
This step is important to ensure the remaining water does not leak out of the tank during
shipping causing damage and/or mold to the rower.
Remove the tank stopper. Use the provided syphon pump to remove the water from your
tank. There will be approximately ½ cup of water left in the tank.
Bucket Rubber Band
Ziplock Bag Allen Key(s)Card
Syphon Pump
Plastic Bag

2
(A) Stand the WaterRower upright. Unclip the bungee from the recoil belt. (B) Pull the handle
to the forward riser while pulling the recoil belt through the other side. Using an elastic band,
secure the handle to the top deck (Band goes around one end of the handle, under the top
deck, and then over the other end of the handle). (C) Wrap the recoil belt around the forward
riser bracket. Tuck the end of the recoil belt through itself and pull tight to secure.
Recoil Belt
Bungee
STEP 1
A
B
C

3
Press the heel rest adjustment button (i) and pull down the Footpads (ii) to remove. It may be
required to slide a card between the footpad cover and the top of the footpads to allow the
pads to slide under the cover to remove.
STEP 3
Footpads
Press Button
to Adjust
(i)
(ii) (ii)
Remove the JCN Nuts and JCB Bolts attaching the footboard to the rails (i). Lay the rower
back down, footboard still attached.
STEP 2
JCN Nut
(x4)
JCB Bolt
(x4)
Allen Key(s)
(i)

4
STEP 5
Remove the JCN Nuts and JCB Bolts attaching the tank assembly to the rails at (i) & (ii).
Remove the tank assembly from the rails. DO NOT disassemble the forward riser or top deck
from the tank.
JCN Nut
(x4)
JCB Bolt
(x4)
(i)
(ii)
Allen Key(s)
STEP 4
Unscrew and remove the Handle Rests (i). Remove the footboard. It may be necessary
to slightly loosen the two bolts on the Top Deck (ii) to remove the footboard. DO NOT
COMPLETELY REMOVE THE TOP DECK BOLTS
Handle Rests
Handle Rest Bolt
(x2)
(ii)
(i)
Allen Key
Top Deck Bolts
Handle Rests
(x2)

5
STEP 7
Remove the seat assembly.
STEP 8
Disconnect the Rear Spacer (i) by removing the female JCN nuts using the Allen key. Wrap
the bungee around the rear spacer and tie it o within itself. Place all bolts, handle rests, and
dolly wheels in a plastic bag for shipping.
Rear Spacer
JCN Nut (x4) Allen Key
STEP 6
Remove the dolly wheels from the rails using the allen key.
(i)
Allen Key