WaterUps Oasis 1240 User manual

Oasis 1240
Scan the
QR Code to go
to the website
Watch the full assembly video for your Self-Watering
Wicking Bed Kit on the Waterup Website.
www.waterups.com.au/product/waterups-oasis-1240-wicking-bed
Watch the full assembly video for assembling the water reservoir
on our website:
www.waterups.com.au/product/waterups-oasis-1240-wicking-bed
1: Take the liner and fold the ends as shown in the video.
2: Push the three tabs in the corners from the outside in and repeat
the enre process for the next three corners, creang the square
base liner.
3: Place the liner inside the planter, make sure the hole in the liner
and the hole in the planter match up.
4: Take one of your cells and the overow pipe and assemble as
shown in the video.
5: Feed the cell and the overow pipe through the hole in the
reservoir and the planter and ensure it sits at in the boom of the
reservoir. Replace the spacer on the overow pipe and ghten the
nut.
6: Take another cell the inlet pipe. With a sharp knife remove the
circle in the cell along the line as indicated in the video.
7: Insert the inlet pipe into the cell. Take note of the three tabs on
the inlet pipe that will t through the three holes in the cell. Apply
some pressure unl it clicks in.
8: Insert this cell in the end of the planter. Decide if you want the
inlet at the side or back.
9: Then take the last cell and place it in the middle.
For suggesons about soil for wicking beds and other relevant
informaon visit our website.
This informaon booklet is printed on recycled paper.
Please compost or recycle this when you are nished.
Before you start
Assembly of the Water Reservoir and Cells
Filling your Planter
www.waterups.com.au |Email: [e-mail] |Phone: [phone]
by
Self-Watering Wicking Bed Kit