5. MAINTENANCE
EN
4. USAGE
4.3. Spa cover and security
d t
t
Press the filter button to activate the water filtration. The green indicator light will turn on when
the filtration system is activated. Please note that filters should be changed every 7 days, or
until they become discoloured.
Note:
- If bubble fucntion is on, the filtration can’t be activated.
Press the heating button to activate water heating and filtering system at the same time. The
green indicator light of filter and red indicator light of heating will turn on at the same time.
The pump dpes not stop heating until the current water temperatire reaches the set tempera-
ture; and the heating system will restart after the current water temperature drops below 35°C
below set temperature automatically.
Maximum heating temperature: 108°F (42°C)
Important:
After 150 cumulation hours of filtration operations, an audible alarm will sound and
the LCD display will show the characters CHG, followed by FIL, to remind you to
change or clean the filter. You can hold the filtering button 5 seconds to turn off the
buzzing. The filtering system will turn off, you can press the button to activate the
filtering system again.
Note:
- With the heating system starting, the filtration system will start working together.
- After turning off the heating system, the filtration system will still work.
- If the bubble function is active, the filtration and heating fucntions cannot be activated.
14 15
5.1. Water maintenance
WARNING: Bad spa water quality can harm your health.
5.2. Cleaning and replacing the filter cartridge
5.2a Disinfection
Depending on the frequency and conditions of use:
- The filter cartridge should be regularly cleaned / replaced every 150 hours max.
- The filter cartridge should be replaced every 150 hours unless cleanable.
- The spa water should be changed every 15 to 30 days.
Use a water tesy kit to control the parameters of the water before using the spa, or at least once a
week.
Use disinfection products fo the spa. The treatment products should be used with caution and it is
imperative to refer to their instructions.
Damage resulting from improper use of treatment products is not covered by the warranty.
1. Water balance
The water balance (pH) must be maintained between 7 and 7.4.
2. Water Sanitation
To sanitise the spa water, we suggest using an active oxygen-based treatment or
bromine placed in a floating dispenser. (Dispenser sold separately).
A dirty filter cartridge may contaminate the spa water and cause damage tp the heating function.
1. Unscrew the filter case by turning it anti-clockwise. Take oiut the filter cartidge from the case.
2. Rinse off the filter cartridge with a garden hose. If the filter cartridge remains dirty and
discoloured, the filter cartridge should be replaced.
3. Put back the cleaned filter cartridge into its case and screw it to the spa.
Water Sanitation:
To sanitise the spa water, we suggest using an active oxygen-based treatment or bromine placed
in a floating dispenser. (Dispenser sold separately).
Seek professional advice and guidance before doing this.
Attention:
Detergent residues and dissolved solids from bathing suits and chemicals may build up on the spa
walls. Use sopa and water to clean the walls and rinse thoroughly with a garden hose using a
direct water spray.
C
M
Y
CM
MY
CY
CMY
K
Wave_Installation and user manual_OSAKA_OUTLINED AND EMBEDDED.pdf 8 10/09/2021 09:50:09
