
· Keep connection cables away from high voltage and/or high current wires.
· Keep connection cables away from door motor and door drive.
· Avoid direct sunlight or other infrared ingress to the receiver (RX).
· Prior to power-on, clean the lenses with a soft, damp cloth.
· Do not bend or twist the edges, and do not scratch the lenses.
PLANNED MAINTENANCE PROCEDURE
· Ensure that the yellow LED is lit (system functioning), then clean the lenses with a
soft, damp cloth.
· Check all plug and terminal connections.
· Perform a detection test by inserting an object greater than 50mm between the TX
and RX.
· The red LED status indicator will light to confirm object detection.
NOTES AND ADVICE
Neither LED in the receiver is lit.
Both the yellow and red LEDs of the door
detector are lit without interruption
between the RX and TX.
The plastic filter is too dirty.
Other infrared equipment is nearby.
The ambient light is stronger than allowed.
There is a system fault.
The cable is broken or not connected.
TROUBLESHOOTING
Door Detector LEDs
Yellow - Power Indicator
Red - Status Indicator