Westinghouse PT-16H610S - 15.6" LCD TV Installation instructions manual

6 mm
6 mm
95 mm
6 mm 6 mm
95 mm
11.5mm
Mounting Guide for PT-16H610S
Tools required
Mounting on wall Mounting under the cabinet
Screwdriver on Drill
5 screws. The screw head cannot exceed 11.5 mm (Diagram A). The length and type
of screw depends on the wall or cabinet surface where the TV will be mounted.
Check with your local hardware store for more screw info.
Pencil or print template to mark screw hold position.
Print out the mounting template or measure and mark the 95 x 100 mm hole positions on
the surface.
Install the last screw in the safety latch to prevent the TV
from sliding when adjusting the viewing angle.
SAFETY LATCH
Hang the TV using integrated mounting holes and slide down to secure in place.
Fold the TV flat.
Install 4 screws into the template marks leaving 5~6 mm of space
between the screw head and wall surface.
Unsnap plastic front bezel from the TV, rotate, and snap
back in place.
Hang the TV using integrated mounting holes and slide
forward to secure in place. Install the last screw in the safety
latch to prevent the TV from sliding when adjusting the
viewing angle.
Print out the mounting template or measure and mark the 95 x 100 mm hole positions on
the surface.
Before mounting the TV, power on, open the setup
menu, scroll to Settings, and select Rotate Video.
This setting will flip the video 180 degrees for
view in the under cabinet mounted position.
1
2
3
4
5
SAFETY LATCH
5
1
2
3
4
A
Install 4 screws into the template marks leaving 5~6 mm of space
between the screw head and under cabinet surface.
1
2
3
Customer Service
866-287-5555 • www.wde.com
© 2008 Westinghouse Digital Electronics, LLC. All rights reserved. Specifications subject to change without notice. ¼, Westinghouse and You can be sure... if it's Westinghouse are trademarks of Westinghouse Electric Corporation. MA-PS-0126-0701

Mounting Template for PT-16H610S
Customer Service
866-287-5555 • www.wde.com
100 mm
95 mm
Tape on wall or under cabinet and mark hole pattern for screws