Weston BUTCHER Series User manual

DUE TO CONSTANT FACTORY IMPROVEMENTS, THE PRODUCT PICTURED MIGHT DIFFER
SLIGHTLY FROM THE PRODUCT IN THIS BOX.
MEAT GRINDERS
09-0501-W (#5 MEAT GRINDER)
09-0801-W (#8 MEAT GRINDER)
09-1201-W (#12 MEAT GRINDER)
09-2201-W (#22 MEAT GRINDER)
09-3201-W (#32 MEAT GRINDER)
09-4201-W (#42 MEAT GRINDER)

9
ENGLISH INSTRUCTIONS
CLEANING INSTRUCTIONS
1. Insert the Head into the Gear Housing with the Feed
Chute facing straight up. You will need to line up the
slot in the Head with the Pin inside the Gear Housing.
Be sure the Head is seated fully into the Gear Housing
(Figure 1).
2. Tighten the Head Locking Knob to lock the Head
into place.
3. Insert the Auger, with the Auger Bearing
attached, into the Head (Figure 2). Align the
Auger Splines with the Drive Shaft of
the Grinder.
NOTE: Periodically inspect the
Auger Bearing for wear. If
the Auger Bearing has
excessive wear, replace it to prevent
head damage.
4. Place the Knife onto the square
part of the Auger Pin (Figure 2). Be
sure the blades of the Knife are facing
outward.
5. Place one of the Grinder Plates
onto the Auger Pin; align the notch in
the Grinder Plate with the Pin in the
Grinder Head.
6. Install the Front Ring Nut. DO NOT
OVERTIGHTEN. Turn the Front Ring Nut
untilit makes contact with the Grinder Plate, then
make 1/4 turn more to tighten into place.
7. Insert the neck of the Tray into the Feed Chute
(FIGURE 3).
8. NEVER operate Grinder without the Tray
secured in place (FIGURE 3).
REFER TO “GRINDING INSTRUCTIONS”
GRINDER ASSEMBLY INSTRUCTIONS
Gear
Housing
Head
FIGURE 1
Head
Locking
Knob
FIGURE 2
Head
Auger Bearing
Auger
Auger Splines
Auger Pin
Knife
Grinder Plate
Front Ring
Nut
NOTE! Be sure the blades
of the Knife are facing out.
WARNING! Before cleaning, assembling or disassembling the
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
FIGURE 3
Tray
Head
Feed
Chute
WARNING!
See Safety
Guard
Instructions
Prior
Operation!