5019 318 33241 LI25BA
D F NL E
GB P I GR NDK FIN
S
INSTALLATION - ASSEMBLY INSTRUCTIONS
The hood is designed for operation in filter version only: Air is filtered through a carbon filter and recycled into the
surrounding environment.
Expansion plugs are provided to secure the hood to most types of ceilings. However, it is necessary to contact a qualified
technician to ascertain suitability of the materials according to the type of wall/ceiling. The wall/ceiling must be strong enough
to take the weight of the hood.
Disconnect the power supply at the home main switch during electrical connections.
Fig.2
Place the template (supplied) Y(Fig. 2) on the ceiling directly above the cooktop, matching the centre of the template (R1)
with the centre of the cooktop (R2).
The sides of the template must be parallel to the sides of the cooktop. Prepare the electrical connection.
Note: The side of the template with the wording “FRONT” corresponds to the hood controls side.
Drill the holes indicated on the template, and insert the plugs.
Fig.3
Prepare the support bracket B, suitably adjusting the length of the cables according to the following formula:
L (cm)= X-36
L = truss extension
X = distance between the ceiling and the bottom edge of the hood
After finding the right length, secure the cables, tightening the lock nuts (Fig. 3c) with a spanner.
Warning: Respect the minimum distance from burners, indicated on the first page of the manual.
Fig.4
Fit the support bracket to the ceiling, feeding the cables for electrical connection through the central hole.
Fix with 3 screws.
IMPORTANT! Detail B (support bracket) is equipped with a wire (yellow/green) which must be connected to the
earth of the household electrical system.
Fig.5
Fix the lighting unit to the hood with 3 screws and crescent-shaped washers.
Note: The inside rim of the lighting unit has chamfers which must match the fixing places.
Fix the cap to the hood with 6 screws.
Fig.6
Apply the aesthetic cap Ato cover the hood, passing the interconnection electrical cable inside.
Warning: Make sure the interconnection cable does not touch the lamps and arrange the excess part using the cable clamps
located at the top of the hood.
Fig.7
Fix the hood to the fixing brackets and secure with 1 screw for each bracket (COMPULSORY FIXING).
Fig.8
Adjust the position of the hood by means of the adjustment screws D.
Fig.9
Insert the control rod in the special seat.
Note! Compulsory coupling direction, with release.
Fig.10
Fix the connection box Fto the support bracket on the ceiling with 2 screws.
Carry out the electrical connection and secure the cables with the cable clamp Gwith 2 screws.
Fix the connection box cover with 4 screws.
Warning! Replacement of the interconnection cable must be carried out by the authorised after-sales technical service.
Fig.11
Insert the cover Ebetween the support cables, making sure they enter the special slots on the cover.
Warning! Leave enough cable so that it passes easily through the slot obtained in the cover.
Secure the cover with 3 grub screws already screwed (or to be screwed) on the support bracket B.
Note: The 3 fixing screws secure the cover by virtue of the friction they exert on the cover itself, and therefore must not be
completely tightened.
Fig.12
Apply the aesthetic tabs I (press-on) to cover the hood fixing rib points
