WHITECROFT LIGHTING Duo 3 Evo User manual

Whitecroft Lighting Limited
Burlington Street, Ashton-under-Lyne, Lancashire OL7 0AX
Telephone [phone] Facsimile: [phone]
Registered No. 3848973 England Registered Office: As above
February 2018 - Rev A
Duo 3 Evo
PK/DUO3EVOINSTAL
SPECIFICATION
Lamp type LED
4000lm - 4000K
3300lm - 4000K
Finish RAL 9003(White)
Materials Plastic Diffuser / Painted Steel
Weight Standard Fitting = 5.5kg
Emergency Fitting = 6.5kg.
Supply 220-240V AC, 50/60Hz
Operating temp 0-25C v
Connection 0.75mm ² to 2.5mm ² input terminal block
Ingress protection IP44 from below IP20 from behind
GENERAL INFORMATION
1) A qualified electrician, in accordance with IEE wiring regulations should carry out
connection to mains wiring.
2) This unit must be EARTHED.
3) Ensure that the rated voltage and frequency requirements are compatible with the
available mains supply.
4) Cleaning of reflectors and lenses should be carried out using clean, soft and lint
free cloths and anti-static cleaning fluid
5) Do not carry out high voltage insulation test, i.e. 500/1000v this may damage
internal components.
Installation Instruction
TECHNICAL SUPPORT
Telephone: [phone]
Email: technical whitecroftlight.com
http://whitecroftlighting.com/
DIMENSIONS
595 117
595

Remove the luminaire from the carton; inspect the visual faces for any scratches
The Box will include the following:
Luminaire
Installation Leaflet
Duo 3 Evo
Whitecroft Lighting Limited
Electrostatic
Sensitive Device
High Voltage
LED's
Whitecroft Lighting Limited
Electrostatic
Sensitive Device
High Voltage
LED's
Duo 3 Evo
Installation
Remove the terminal access
cover by removing the 2 screws
as shown
Lift and tilt the fitting into the
grid and center
(Only suitable for exposed
flat grid T15 or T25 ceilings)
Wire mains cable though cover
lid and strip/wire into terminals
use cable restraint after wiring
Terminal
Wiring
Cable Restraint
Earth Lead Attached
Connect batteries on emergency verison