Whittier Wood 1357GACa User manual

P.O. Box 2827
Eugene, OR 97402 USA
Production Code:
VN 08/17
McKenzie Headboard
Model #
1357GACa 1357CAFa
McKenzie Full/Queen Headboard
1358GACa 1358CAFa
McKenzie King/Cal-King Headboard
GAC = Glazed Antique Cherry finish
CAF = Caffè finish
Assembly Instructions
IMPORTANT NOTES:
•For normal household use only. Not recommended for commercial use.
WARNING
Drilling, sawing, sanding or machining wood products can expose you to
wood dust, a substance known to the state of California to cause cancer.
Avoid inhaling wood dust or use a dust mask or other safeguards for
personal protection.
For more information go to: www.p65warnings.ca.gov/wood
This product can expose you to chemicals, including formaldehyde,
which are known to the State of California to cause cancer.
For more information go to: www.p65warnings.ca.gov/furniture
DESIGN SUBJECT TO CHANGE WITHOUT NOTICE.
CUSTOMER SERVICE
If you ever have questions about your furniture, please do not hesitate to contact us. In the unlikely event you need a
replacement part; we can make those parts available through an authorized Whittier Wood Furniture dealer. If you
cannot order replacement parts through your dealer, please contact our customer service department.
Hours: Our friendly customer service staff can be reached:
Monday-Friday 8:00 a.m. to 5:00 p.m. (Pacific Time).
You may leave a message 24 hours a day, seven days a week.
Customer Service: 800-653-3336 • Outside the U.S.: 541-687-0213
Fax: [phone]• Email: [email protected]
Thank you for allowing us to help you furnish your
home. We are certain you will be delighted with
your new furniture for many years to come.

1357GACa 1357CAFa McKenzie Full/Queen Headboard
1358GACa 1358CAFa McKenzie King/Cal-King Headboard
Parts List
1357GACa_1357CAFa_1358GACa_1358CAFa — Page 2 — 08/17
Please identify the parts and check that quantities received match those on this list.
If you need to replace a part, refer to the following letter and part name.
Part
Description
Quantity
Aa
Headboard Assembly
1
E
18mm Flat Washer
6
I
#14 x 1-1/4" Pan Head Screw
6
J
1/4" Flat Washer (inserted)
6
K
5/16" x 3" Lag Bolt (inserted)
6
L
#8 x 1-1/4" Pan Head Screw (inserted)
4
1357 shown in the illustrations.
Assembly Instructions
Tools Required: Drill, 1/8" bit, Phillips screwdriver.
IF YOU ARE USING A HOLLYWOOD BED FRAME:
1. Adjust the Hollywood frame to fit your mattress and box spring.
2. Place the Headboard (Aa) against the end brackets of the frame and mark the locations for the
screws. Drill pilot holes approximately 1-1/4" deep. (To make sure you don’t drill deeper,
measure 1-1/4" up from the end of the drill bit and wrap a piece of tape around the bit. Stop
drilling when the edge of the tape meets the wood.)
3. Position the Headboard (Aa) against the frame and attach using six #14 x 1-1/4" Pan Head
Screws (I) and 18mm Flat Washers (E).