Wholesale Interiors BBT 6878 User manual

MODEL : BBT 6878 QUEEN BED
Read this instruction carefully. See hardware and furniture part list for guidance.
Be sure all parts are complete, before you assemble. Place all wooden furniture
parts on a clean and flat soft surface to prevent from being scratched.
Follow the figure to start assembling.
CAUTIONS :1. Do not FULLY - TIGHTEN the nut or nut bolt until all nut or bolt is ready assembed.
2. Do not OVER - TIGHTEN the nut or bolt to avoid causing damages to the thread.
3. Keep all hardware parts out of reach of children.
NOTE : THE LIST AND QUANTITY SHOWN ARE FOR 1 UNIT ASSEMBLY.
Tool needed : Screwdriver & Rubber Mallet (not provider).
ASSEMBLY INSTRUCTIONS HARDWARE LIST
ITEM DESCRIPTION QTY
1JCBC BOLT M6 x 40mm 10 PCS
2JCBC BOLT M6 x 45mm 8 PCS
3JCBB BOLT M8 x 40mm 7 PCS
4M6 FLAT WASHER 6 PCS
5M8 SPRING WASHER 7 PCS
6M8 FLAT WASHER 7 PCS
7WOOD DOWEL M8 x 30mm 4 PCS
8BED SLAT SIDE FITTER 26 PCS
9BED SLAT CENTER FITTER 13 PCS
10 WOOD SCREW M3.5 x 16mm 8 PCS
11 WOOD SCREW M4 x 20mm 2 PCS
12 M4 ALLEN KEY (BALL SHAPE) 1 PC
13 M5 ALLEN KEY (BALL SHAPE) 1 PC
PART LIST
ITEM DESCRIPTION QTY
AHEADBOARD 1 PC
BFOOTBOARD 1 PC
CHEADBOARD LEG SUPPORT WOOD 2 PCS
DFOOTBOARD LEG SUPPORT WOOD 1 PC
EBED LEG 4 PCS
FSIDE RAIL 2 PCS
GHEADBOARD WING 2 PCS
HSIDE RAIL SUPPORT WOOD 2 PCS
ICENTER RAIL 1 PC
JCENTER SUPPORT LEG 3 PCS
KCENTER SUPPORT WOOD 2 PCS
LBED SLAT 26 PCS
1 of 3
STEP 1 STEP 2
Loosen the pre-inserted
bolt on the
headboard and
footboard using Allen
key ball shape (13)
13
A
B
Remark : Big hole face up,
small hole face down.
STEP 2.1
x 4
CC
E
1
12
D
E
STEP 2.2
x 4
Take out HEADBOARD WING (G) from the HEABBOARD (A).

STEP 3 STEP 4
ASSEMBLY INSTRUCTIONS 2 of 3
E
E
65 3 13
65313
STEP 5
F
A
F
F
G
7
4112
x 2
G
STEP 6
4
1
12

* When moving the bed position, the center support legs
must be adjust to be straight to avoid any broken problem.
STEP 7 STEP 8
ASSEMBLY INSTRUCTIONS 3 of 3
STEP 6.1
STEP 6.2
I
J
I
11
10
K
K
I
Palm
Palm
89
8
L
L
L
L
L
9
8
STEP 8
212
STEP 8
H