Wholesale Interiors CANDACE User manual

CANDACE - KB
LIST
L
R
(LEFT)
(RIGHT)
STEP 1
Begin assembly by attaching each headboard leg (2) & (3) to the bottom of the headboard cushion
(1) by aligning the hole and securing with 3 Allen Bolts (C) , 3 spring washer (F) , 3 flat washer
(G) per leg using L-key (J). (DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)
STEP 2
Attach each footboard legs (5) to the bottom of the footboard cushion (4) by inserting a dowel (E)
& securing with 1 Allen Bolt (D) per leg using L-key (J).
NOTE : AFTER A FEW DAYS , IT WILL HAVE ACCLIMATIZED TO THE ENVIRONMENT.
PLEASE TIGHTEN ALL HARDWARE. CHECK TIGHTNESS OD ALL SCREWS EVERY 6-8 WEEKS.
Make sure the cleat is
on outside edge
Do not fully tighten screws
until assembly is complete
and the bed is level

I
9
10
STEP 5.2
STEP 3
Attach side rail support leg (8) to the join of the side rail (6) and
side rail (7) by securing with 4 Allen Bolts (B) , 4 spring washer
(F) , 4 flat washer (G) per support using L-key (J).
STEP 4
Attach side rail to the headboard leg (2) & (3) and footboard (4).
Aligning holes and securing with 2 Allen Bolts (A) per each and
using L-key (I).
(DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)
STEP 5
Attach support legs (10) to slat (9) by securing with 1 Allen Bolt
(C) per support (2 support legs per slat as shown). Attach
slat (9) to side rail by securing with 1 screws (H) per each side.
Tighten all screws using philips head screw driver (not included).
Tighten all bolts on step 2 & 3 using the L-key (J) following step 4
using the L-key (I) that has been provided.
STEP 6
ASSEMBLY
COMPLETED
NOTE : AFTER A FEW DAYS , IT WILL HAVE ACCLIMATIZED TO THE ENVIRONMENT.
PLEASE TIGHTEN ALL HARDWARE. CHECK TIGHTNESS OF ALL SCREWS EVERY 6-8 WEEKS.
Do not fully tighten screws
until assembly is complete
and the bed is level