Wholesale Interiors BBT6696 User manual

ASSEMBLY INSTRUCTIONS
MODEL : BBT6696 TWIN BED 1 OF 4
Read this instruction carefully. See hardware and furniture part list for guidance.
Be sure all parts are complete, before you assemble. Place all wooden furniture
parts on a clean and flat soft surface to prevent from being scratched.
Follow the figure to start assembling.
CAUTIONS :1. Do not FULLY - TIGHTEN the nut or nut bolt until all nut or bolt is ready assembed.
2. Do not OVER - TIGHTEN the nut or bolt to avoid causing damages to the thread.
3. Keep all hardware parts out of reach of children.
NOTE : THE LIST AND QUANTITY SHOWN ARE FOR 1 UNIT ASSEMBLY
Tool needed : Screwdriver & Hammer (not provider).
PART LIST
ITEM DESCRIPTION QTY
AHEADBOARD 1 PC
BFOOTBOARD 1 PC
CSIDE RAIL 2 PCS
DSLAT 1 SET
EBED LEG 4 PCS
FSIDE RAIL SUPPORT WOOD 2 PCS
GHEADBOARD WINGS (L&R) 2 PCS
HHEADBOARD & FOOTBOARD
SUPPORT WOOD 2 PCS
HARDWARE LIST
ITEM DESCRIPTION QTY
1JCBC BOLT M6 x 40mm 8 PCS
2JCBC BOLT M6 x 70mm 12 PCS
3JCBB BOLT M8 x 50mm 8 PCS
4M6 FLAT WASHER 4 PCS
5M8 FLAT WASHER 8 PCS
6M8 SPRING WASHER 8 PCS
7WOOD SCREW M4 x 38mm 6 PCS
8WOOD DOWEL M10 x 30mm 12 PCS
9M4 ALLEN KEY (BALL SHAPE) 1 PC
10 M5 ALLEN KEY (BALL SHAPE) 1 PC
HEADBOARD
HEADBOARD
STEP 1
8
G
F
H
8
x 2
x 2
1.1 Open the zip at the rear side of headboard and
take out the heardboard wings.

ASSEMBLY INSTRUCTIONS 2 OF 4
STEP 2
STEP 4
STEP 3
STEP 5
H
E
56
310
C
B
B
19
I
E
H
C
STEP B
x 2
x 2
STEP A STEP A STEP B
4
1
9
A
G
x 2
10

ASSEMBLY INSTRUCTIONS 3 OF 4
HEADBOARD
STEP 7
STEP 8
STEP 6
2
9
H
H
2
F
H
F
9
F
2
9
H
H
x 2
x 8
x 2
x 2
x 2
STEP A
STEP B
STEP B
STEP A
H
Don't screw tied
Don't screw tied
Don't screw tied 2(i)
2(ii)
2(iii)
2(iv)
NOTE : Base on the diagram show 2(i),2(ii),2(iii),2(iv) use the sequence
to assembly item H.
(Make sure the sticker "-> HEADBOARD" faced to headboard [A].)
NOTE : Make sure the floor is
clean and smooth
when put down the bed
to prevent scratches.
2(i)
2(ii)
2(iii)
2(iv)

ASSEMBLY INSTRUCTIONS 4 OF 4
* When moving the bed position, the center support legs
must be adjust to be straight to avoid any broken problem.
STEP 9 STEP 10
D
7
F
5
6
3
10
STEP 11
**Finish step 9,
Please screw tied the step 6,7,8 bolt.