Wi-Tek WI-PS518GF User manual

LED Explanation
Power
Installation Guide
5/816/24/48-Port PoE
Switch
On: Power on
Off: Power off
PoE/Link
For 100M port:
Yellow light Solid On: Power supplying for PD.
Green light Solid On: PD connected to the PoE port,
but no data transmission.
Flashing: Data transmitting.
For 1000M port:
Yellow light Solid On: Running at 1000Mbps.
Green light Solid On: Running at 100Mbps.
Flashing: Transmitting/receiving data.
Note: For simplicity, we will take WI-PS518GF for example through this Guide.
Yellow
Green
SFP
Package Contents: Switch, Power cord, QIG, Rackmount Kit(except 5/8-port Model).

Functional switch
Frequently Asked Questions (FAQ) Functional switching Explain
Q1. The Power LED is not lit.
If the Power LED is not lit, check as follows:
A1: Make sure the power adapter is connected to the switch
with power source properly.
A2: Make sure the voltage of the power supply meets the
requirements of the input voltage of the switch.
A3: Make sure the power source is ON.
Q2. The PoE/Link LED is not lit when a device is
connected to the corresponding port.
A1: Make sure that the cable connectors are firmly plugged
into the switch and the device， the Ethernet cable
should be pure cooper CAT5/5e/6.
A2: Make sure the PD is compatible to the switch, please check
detailed PIN information in the PIN definition table.
A3: The cable must be less than 100 meters long (328 feet) if it
doesn’t support the Extend function .
Gear
Function
Explanation
Default
Standard
All ports free communication, suitable for common
data transmission environment.
VLAN
Port
isolation
The 4 PoE ports are isolated from each other, which is
suitable for the use of wireless AP, which can
effectively restrain the network storm and improve the
performance of the wireless network.
Extend
250 meters
supply
Ultra far 250 meters PoE transmission , can solve the
monitoring project and wireless coverage project
power supply distance problem.
For technical support and other information,
please visit: www.wireless-tek.com
The PIN definition of Wi-Tek PoE
Warranty Card
For managed model, If you want to configure L2 advanced function,
please launch a browser and type 192.168.0.1 into address bar. The
default username and password are both admin in lower case.